Part Number: LM74912-Q1 Tool/software: Hi Shiven,
This is Ryusuke, who asked in the thread below before. I am sorry for the late reply.
(2) LM74912-Q1: condition to latched off - Power management forum - Power management - TI E2E support forums…
Part Number: LM74912-Q1 Other Parts Discussed in Thread: LM74912 Tool/software: The customer feedback that LM74912 can not work normally. HGATE voltage is low.
Could you help to review the schematic?
Part Number: LM74912-Q1 Other Parts Discussed in Thread: LM74930-Q1 Tool/software: Hello! I'm working with the LM74912-Q1 ideal diode controller in a high-side switch application. By default, it blocks reverse current using its built-in gate control logic…
Part Number: LM74912-Q1 Tool/software: Hi all,
I think the potential difference between Vin and Vout is large.
I think it is less than 500 mV because it is connected to the series with 2 FETs ON in the normal usage.
Do you have the test result of…
Part Number: LM74912-Q1 Other Parts Discussed in Thread: LM74900-Q1 Tool/software: Dears,
My customer needs to know the LM74912-Q1 Functional Safety FIT. Can you help provide the LM74912-Q1 Functional Safety FIT Rate, FMD, and Pin FMA documents? Thank…
Part Number: LM74912-Q1 Other Parts Discussed in Thread: LM74912 Tool/software: Hello,
can i use this component for Hot-swapping and ORing? actually the back-to-back FET configuration with current sensing shall ensure hotswapping function alongside…
Other Parts Discussed in Thread: LM74912-Q1 , LM74912 , LM74900-Q1 , LM74900
Hi all, Please help me.
As we discussed in the past, the LM74912-Q1 is exhibiting unexpected behavior.
LM74912-Q1: condition to latched off - Power management forum - Power…
Part Number: LM74912-Q1 Other Parts Discussed in Thread: LM74912 Tool/software: Hi all, I'm working on a design involving the LM74912 ideal diode controller, and I'm wondering if it supports a common-source MOSFET configuration (as opposed to the typical…
Part Number: LM74912-Q1
Tool/software:
Hello,
I have 3 questions.
What is the state of the FLTn with EN being in low state?
Can I use the FLTn pin to enable the LM74912-Q1?
What is the start-up behavior of the FLTn pin?
Hi Shiven,
Any ideas for questions above:
1. Is the different behavior due to differences in EMVs (e.g. layout)?
2. Or is the linear operation bandwidth different in these devices ( LM74912-Q1 vs. LM74720)?
3. What is the bandwidth of linear operation…
