Part Number: PROCESSOR-SDK-AM335X Other Parts Discussed in Thread: LM75A , AM3352 , SYSCONFIG
We are using LM75A temperature sensor to measure the temperature value of our custom board.
LM75A Temperature is directly connected to am3352 I2C0 bus using…
Part Number: LM75A Other Parts Discussed in Thread: LM70 , LM75B , LM73 Hi Sir,
May I know the heat flow used on LM75A which pin-out?
Temperature sensors: PCB guide lines for surface mount devices: https://www.ti.com/lit/an/snoa967a/snoa967a.pdf
Part Number: LM75A Other Parts Discussed in Thread: TMP1075 , Hi Team,
The datasheet of LM75A mentioned the Configuration Register of D5~D7 as below:
D5–D7: These bits are used for production testing and must be kept zero for normal operation.
Part Number: LM75A Other Parts Discussed in Thread: TMP117 , TMP116 Hi Team,
There is a question of LM75A. In the datasheet, recommended operating conditions of TJ temp range is -55C~125C.
What's the absolute maximum ratings of Tj Max? Can we support…
Part Number: LM75SW-LINUX Tool/software: TI C/C++ Compiler Our core chip is Amlogic T972,
and we use this file to build the driver, but we can't compile success,
there lost some definition in head file,
please help provide some solution for us, thanks…
Part Number: LM75A Other Parts Discussed in Thread: ADC128D818 Q1:I2C interface electrical characteristic, What is the maximum allowable rise time?
Q2:If SDA and SCL rise time is 3.2usec, is there a problem happen?(SCL frequency is 25kHz）
Is there any…
Part Number: LM75A Hi TI expert,
We are now using LM75AIM/NOPB, here is a question, please help to check it.
If the time interval from power-on to start access is less than about 120ms, it is possible that the device will enter shutdown mode and fail…
Part Number: LM75A Other Parts Discussed in Thread: LM75B , , TMP1075 HI Team,
I have some questions about LM75, could you help to reply these questions below.
Customer use LM75BD (NXP) solutions, we try to propose our solutions to them.
The project timescale…
Part Number: LM75A Other Parts Discussed in Thread: TMP1075 , SYSCONFIG , TMP116 , BOOSTXL-BASSENSORS , BOOSTXL-SENSORS , CC2652RB Is there any SPI example for CC2652 to communicate with sensor and get the data ?
Any re-usable code will be helpful.
Part Number: LM75A Dear supporting team,
I've problem with LM75A which i2c communication failed after few hours, I work with linux OS environment and coding C to read i2c bus and calculate temperature value using LM75. Main board is a custom board using…