Part Number: LM76002 Hello,
I want to purchase LM76002RNPR but is not available in mouser, digikey lead time is 6 weeks.
In those websites LM76002RNPT is available, Can you tell me what is difference between these two?
Can i purchase LM76002RNPT instead…
Part Number: LM76002 Hi
Pluese let me ask you about inductor of LM76002.
My customer will use LM76002 the following condition.
But they will use NS12575T330MN as inductor because it is cheaper than the inductor of 10uF.
Can they use this inductor with…
Part Number: LM76002 Other Parts Discussed in Thread: LM43602 hello,
from the block diagram in the datasheet there is difference below between LM43602 and LM76002. could you tell me what the real difference between them?
1. in the 43602 the PFM detector…
Part Number: LM76002 On LM76002EVM, MODE pin is connected to VCC for FPWM operation.
Is this connection no problem although there is comment "TI does not recommended loading this pin by external circuitry." on datasheet?
Can we connect MODE…
Part Number: LM76002-Q1 Hello Team, please could you explain following values in the table which we cannot find in the datasheet description
Means this that part will be disabled by EN-Voltage lower than 0.3V and Enable higher than 1.2V?
Many Thanks …
Part Number: LM76002 Other Parts Discussed in Thread: LM76003 Tool/software: WEBENCH® Design Tools I took the LM76002 and the LM76003 into TI WORKBENCH under the same power specifications and was given a Voltage Feedback of 1V for the LM76003 and a a…
Part Number: LM76002-Q1 hello,
datasheet says the NC pin between VIn and GND (pin 23) need to be connected to GND to improve thermal and board level reliability. Is it ok to leave it open for good pin FMEA?
Part Number: LM76002 Other Parts Discussed in Thread: TPS62110 , Hi
Can I use TPS62110 or LM7600 using Fly-Buck topology the followung condition?
Vin=12V or 50V
Part Number: LM76002 Hello guys,
One of my customers is evaluating LM76002 using the device EVM for their next products.
Their evaluation conditions are follows.
- EVM parts were not changed from default values.
- in Forced…