Part Number: LM8365 Other Parts Discussed in Thread: LM8364 ,
Dear Team
Scope : to pass Voltage dips test 10ms
I need a support for Correct brownout function ic for UCC28180D PFC controller 1000W , i tried with LM8365 reset ic based on your thread…
Part Number: LM8365 Other Parts Discussed in Thread: TPS3890 , TPS3808 Hello team,
My name is Oliver Kim and I wonder whether I can use the LM8365 with 10s delay time.
As you know. figure 12 of LM8365 datasheet only shows the only small range of time…
Part Number: LM8365 Other Parts Discussed in Thread: TPS3890 Dear TI Team,
I want to use the LM8365 to give a Reset Delay.
The delay time we need is 3 seconds.
If 1uF is on the data sheet, it is indicated as 1.2 seconds.
Can you tell me the value…
Part Number: LM8365
Hi team,
Below is my schematic.
My question is LM8365 reset out low level 0.2V - 0.5V have risk connot shunt down U33 LDO? also you can recommend or advise suitable solution. thanks.
Part Number: LM8365 Hi there,
For the delay time settings, is there an equation to calculate for the Cd value. The datasheet only gives CD = 0.1μF Output Time delay = 130 ms Output Time delay and CD = 1μF Output Time delay = 1.2 s, but I need a delay…
Part Number: LM8365 Other Parts Discussed in Thread: TPS3890 , TPS3896 , TPS3895 , TPS3808 Hello team
My customer is looking for following spec Reset ICs.
I am not familiar with reset ICs, Could you tell me the best solution ?
(Ratng is Catalog…
Other Parts Discussed in Thread: LM8365 Hi,
We got a question from customer about LM8365. Could you help us?
[Question] - When Isink is several uA to several tens of uA, how much is the /Reset output voltage(Vol)? I think we can calculate this value…
Other Parts Discussed in Thread: LM8364 , LM8365 Hello,
I need to add a delay to a LM8364 circuit, but I can't spin the PCB. I've found the LM8365 and need to know if the N/C pin (Pin #4) is internally connected. My plan is to modify existing boards…
Other Parts Discussed in Thread: LM8365 Hi,
I am working with the LM8365 and wanted to know if the input voltage goes to zero, does the output sink any current?
It is being used as an undervoltage detector and seems that if:
Vin = 0, no alarm…
