Hi Lauren,
Thank you for checking this. A 10MHz clock speed would be above our specification limits, but 5MHz is acceptable, so that was a good test.
Is there any other traffic on their SI/O Line that isn't shown here?
Also, it is difficult to gauge…
Part Number: LM95071 Hi, Recommended circuit has been changed due to revision of the data sheet. 10kΩ resistor connection pin has been changed from UCxSOMI to UCxSIMO. Which circuit is correct? And Could you tell me the reason for the change? Regards…
Part Number: LM95071 Other Parts Discussed in Thread: LM71 , Hello,
Can you confirm if the LM71* and LM95071* devices are "100% compatible" at the software driver level?
I consider adding LM95071* as additional source to the LM71* that we currently…
Part Number: LM95071 Hi, CDM specs on the data sheet has been changed. Is this change due to material changes? Or is this change that reflects the retest results? Could you tell me about the background of this change. Regards, Yusuke
Part Number: LM95071 Dear Sir,
The temperature sensor LM95071 is used, but In rare cases, a value higher than the specified temperature data may be read. ※ 1550 data is read out. The next read will be normal data, but Please let me know if any cause…
Part Number: LM95071 Hi, Could you tell me about CDM spec? The following contents are described in the data sheet. This should be ±250V not ±200V, shouldn't it? Best Regards, Yusuke
Hi Brandon-san,
Thank you for your response.
The board temperature is measured by using multiple LM95071. Our customer has confirmed the same symptom as the following post and LM95071 will operate normally by restarting the device(power-on/off) if…
Hi Ren-san,
Thank you for your comment.
I understood that you haven't tested excessively long periods but LM95071 will work properly. Please point out if my understanding is wrong.
Best regards, Kato
Part Number: LM95071 On page one of the LM95071 datasheet (SNIS137F, revised May 2019), there is a 10K resistor shown connected between UCxSOMI (slave out master in) on the microcontroller and SI/O on the LM95071. Shouldn't this resistor be place between…
Part Number: LM95071 Hi,
The graph for "typical output noise at 30℃" is mentioned in LM95071 data sheet, so could you please tell me the serial clock period and the sample number per second for these data ?
Best regards, Kato
