Part Number: LM98725 Hi team,
A question from one of our customers:
The LM98725 is 8bit*2 in CMOS output format, the customer docks a chip that is an 8-bit DVP interface, but the software does not allow sampling eight bits MSB and eight bits LSB on…
Part Number: LM98725 Hi all, I have a question about CISb mode. I have a CIS sensor, and this sensor has 3 output port(SIG1/2/3 pins).
These ports are using the three part of each line. CIS sensor read the one line and give the separated three part…
Part Number: LM98725 Hi support team.
Would you please provide the information that the latency from SH_R_rescync(SH_int) rising edge to SH interval rising edge as TBD in DS P56(fig.37) - P60(fig.41)?
Best regards,
Higa
Part Number: LM98725 Hi Team,
Can the IC lm98725 be use for timing generation and data acquisition for CCD S11510. The output speed frequency for the ccd is typically 250 KHz.
if not,
could you please mention the reason and suggest any document…
Hi Robert,
First of all sorry for late reply.
Q1. TI doesn't provide firmware example, a generic example may cause more complications since the firmware needs to match customer application.
Q4. The simple answer is yes. SH has two periods: …
Hello,
Changing the pixel clock to half the value from (from 21.6 MHz down to ~10MHz) also caused the jitter to be twice as big in time (from ~20ns --> ~40ns). That means that the jitter appears to be equal to one INCLK period (INCLK = ADCCLK = 2*PIXCLK…
Thanks Inaki!
We will continue our conversation on the other post. Hopefully now that this post is in the correct forum, we may get responses from the community as well.
Part Number: LM98725 Hi,
I am facing a similar issue with the CCD signal processor device in bench setup.
I find the data output to have random dips to 0V as shown below.
The above plot shows the output voltage(calculated from code) vs number…
Part Number: LM98725 Dear. experts
I'm using LM98725 on MFP scanner.
I have few question about it.
1. When I start MFP and LM98725, sometimes the PLL don't get locked.
But if I restart MFP, it works well.
Have you ever had any issue about…
