Part Number: LMG1020 Tool/software: Hi TI team, I am using the LMG1020 as a fast rise time driver, and I have attached my schematics and oscilloscope screenshots for reference. The screenshots show a measured rise time with a scope that can measure less…
Part Number: LMG1020-Q1 Hi, I was trying to find the Materials declaration for LMG1020QYBVRQ1, but it turns out there isn't one available. Could I get the information for the composition of the IC?
Part Number: LMG1020 Tool/software: Hi Ti Team,
I was planning to build a short-rise time signal using this LMG1020, can I use a crystal that generates a 1MHz clock to IN+ and IN- to GND and get an output with a shorter rise time of less than 1ns?
Part Number: LMG1020 Other Parts Discussed in Thread: OPA357
Tool/software:
Hello team. I have such a task, to build a laser driver that is modulated by a 40 KHz sinusoidal signal. Output power is at least 300 mA. A separate generator has already…
Part Number: LMG1020 Hi,
I'm working on laser diode drivers and I designed a circuit. Circuit is working but sometimes the LMG burns out and I can't understand why. I think ground bouncing is main reason for that. I didnt do kelvin connection on GaNFET…
Part Number: LMG1020-Q1 Other Parts Discussed in Thread: LMG1020 , UCC27532 , UCC27517A Dears,
I need technical insight for the following issue.
I have the requirement of Gate pulsing of an RF GaN FET and pulsing requirements are as below,
The device…
Part Number: PSPICE-FOR-TI Other Parts Discussed in Thread: LMG1020 Hi TI Support Team,
I downloaded the Pspice Transient Model (Rev C) in order to attach the model with the LMG1020 component in my Altium Designer 17.1.9 version. When I extracted the…
Part Number: PSPICE-FOR-TI Other Parts Discussed in Thread: LMG1020 Hi TI support team,
I downloaded the Pspice Transient Model (Rev C) in order to attach the model with the LMG1020 component in my Altium Designer 17.1.9 version. When I extracted the…
Part Number: LMG1020 Tool/software: My situation is this: I am designing a circuit to drive a semiconductor optical amplifier (SOA) on and off at 50% duty cycle as fast as possible. High extinction ratio is required. I would ideally like to switch around…
Part Number: LMG1020 Tool/software: Dear TI experts,
My customer made their schematic using LMG1020. Could you review this schematic?
Best regards,
Chase
