Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210
Hello Experts,
The scope picture of the LMG1210EVM-012 The green HO test point shows a hiccup in the falling edge (red arrow) which finally completes it's drop at the same time the…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210 , Hi,
I'm a little bit confused while analyzing designs from TI.
I was facing an issue of huge power supply ripples while driving half bridge circuit using LMG1210 (Even with a 7…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210 , LMG1210EVM , LMG3100R044 , LMG2100R044 Tool/software: Hi team,
I have two questions regarding the LMG1210:
Is there any mistake in the following measurement method and procedure…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210 Tool/software: Hello,
I am trying to drive a load as close to 50MHz as possible without any thermal throttling from the LMG1210. Using the eval board, I was able to get to about…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210
Tool/software:
Hello.
I am using the LMG1210 to drive a full H- bridge, but it heats up when I apply a 5MHz PWM signal. For testing i set supply voltages 10V DC, and the current…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210 Tool/software: Hi, I found out that the C-boot is not charging up to 5V at every switching cycle. I'm attaching the scope traces of the HB-HS w.r.t other signals. The board was supplied…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210 Hi ,
As the EPC2001 GaN FET is able to source 25 A .
What are the changes required to do in this EVM to get 25A current out.
With Regards,
Ganesh
Part Number: LMG1210 Dear Sir,
We are having difficulty testing the LMG1210EVM-012, we are using a 10 Volt power supply for the input bias supply, 26 volt for the input DC supply while PWM signal is square wave 1MHz' 4V p-p and duty cycle between 20…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210 Hi
My customer is using LMG1210EVM-012.
He wants to use the LMG1210 to operate the piezo.
in the VOUT, can it makes square waveform as 100V, 5MHz?
Also, The heat generation on…
Part Number: LMG1210EVM-012 Other Parts Discussed in Thread: LMG1210 We are having difficulty testing the LMG1210EVM-012, we are using a 10 Volt power supply for the input bias supply, 20 volt for the input DC supply while PWM signal within a range of…
