Part Number: LMG3526R030 Other Parts Discussed in Thread: LMG3422R030 , LMG3522R030 Hi, Could you please share the separate Eon and Eoff data curve for LMG3526R030, or LMG3522R030? Even for LMG3422R030, its Eoff data is hard to extract from the datasheet…
Weird. Hopefully it's the machine and not you (LOL).
I'll close this and let Shikhar know that there was no success, but that you'll try installing on a new computer.
David
Part Number: LMG3522R030 Other Parts Discussed in Thread: LM5156 , Team,
Customer would like to implement a BOOST with LMG35xxx drieven by an analog controller.
Assuming that LM5156 would be used as controller what driver circuit would you recommend between…
Part Number: LMG3522R030 Hello,
Table 6.3 in the datasheet specifies the recommended inductance for Lbbsw.
is there a specific inductor that TI recommends, or any 4.7 uH (with > 1 A current rating) should work?
For example, this one: https://www.digikey…
Part Number: LMG3522R030-Q1 Other Parts Discussed in Thread: LMG3522EVM-042 Hello,
in datasheet it is mentioned on page 3.: "Used to anchor QFN package to PCB. Pins must be soldered to PCB landing pads. The PCB landing pads are non-solder mask defined…
Part Number: LMG3522R030 Hi Everyone,
I have downloaded the PLECS simulation model of the LMG3522R030 device and thereby I obtained remarkably low temperature rise of the GaN FET.
For test purpose, I checked the behaviour with a simple Buck configuration…
Part Number: LMG3522R030 Other Parts Discussed in Thread: LMG3410R070 , LMG3410R150 , LMG3410R050 Hi team,
My customer is looking for a GaN solution and currently looking at competitor device TK12A60W.
I promoted LMG3522R030 to the customer but had trouble…
Part Number: LMG3522R030 I've had this question come up a lot when deciding between top-side and bottom-side cooled devices - what is the general recommendation for what type of cooling methodology is used? Devices that are considered are LMG3522…
Part Number: LMG3522R030 Hello team,
I am looking for the synbol and footprint for the above specified device in order to draw the schematic.
Regards,
Neha Agarwal
