Part Number: LMH0002 Tool/software: for providing output of the SMPTE 292M video data from the FPGA we want the physical layer interface between FPGA and coaxial cable for that we want to use the LMH0002 cable driver.
we want to conformation about that…
Hi Miyajima-san,
Based on the datasheet, we are clear that the LMH0002 can comply to the ASI standards, however, with your measurement setup it is unclear whether or not the device will meet the p2p ASI specification.
Best Regards,
Nick
Part Number: LMH0002 Other Parts Discussed in Thread: CLC007 , CLC006 , LMH1297 Hi,
1. The datasheet for LMH0002 (on page 3) mentions the Output voltage swings of between 750mVpp to 1100 mVpp. Is it correct to assume that this is the nominal range of operation…
Part Number: LMH0002 Other Parts Discussed in Thread: LMH1218 Hi Team, My customer wants to use LMH0002 with supporting MADI. Can he also apply the following 6-dB passive attenuator block? https://www.ti.com/lit/an/snla299/snla299.pdf Best Regards, Yaita
Part Number: LMH0002 Other Parts Discussed in Thread: LMH0044 , , LMH0324 Hi team,
Whether LMH0002 and LMH0044 can transmit LVDS signals with rate of 100M at least 100m distance. If not, can you recommend a solution? Thank you in advance.
Best wishes
A…
Part Number: LMH0002 Other Parts Discussed in Thread: DS10CP152 , Hi,
I would like to interface OUT0+- from DS10CP152 (crosspoint switch) to SDI/nSDI input from LMH0002 cable driver, could you please advise how to proceed (capacitor? resistor ? network…
Part Number: LMH0002 Refer to the Typical Application on the datasheet / SDO (Serial data complement output) side output is BNC connected Although there are devices that can recognize signals and devices that can not be recognized.
/ SDO is negative polarity…
Part Number: LMH0002 Other Parts Discussed in Thread: LMH0397 Is there an RREF value that would allow reducing the SE output swing to be between 300mVpp and 600mVpp?
Regards,
Josh
