Part Number: LMH6586 Tool/software:
I plan to use the LMH6586 to multiplex an MCU's GPIO pins as shown in the provided schematic. The 32 inputs will be connected to LEDs and buttons, while the 16 outputs will interface with 16 GPIO pins (e.g., PORTA…
Part Number: LMH6586 Dear Team,
We are using LMH6586 for run time switching. All outputs will be in shutdown mode initially and we do switching and then enable the required channel. What we are seeing is that when some input to output combination is…
Part Number: LMH6586 I am using 4 LMH6586 Chips for Stanag3350B signals, where R, B, CSYNC channel doesn't have sync and G channel has sync. So,
R, G Channel :
Vmin - 0 V; Vmax - 1 V
B Channel:
Vmin - (-0.3 V); Vmax - 0.7V
CSYNC:
Vmin - 0V;…
Part Number: LMH6586 I am using LMH6586 in my design. I am selecting 3 outputs among 32 inputs
Inputs will be in Stanag format. From the datasheet of the above IC, I found the quiescent current. Could you please let me know, how to calculate the current…
Part Number: LMH6586 We are using LMH6586 in our design. Could you please share the PCB Board File for reference.
In datasheet, they are recomending to use 300mV Clamp voltage for optimum use. what is the advantage of it.
If I clamp it by 300mV, does…
Part Number: LMH6586 Hi Team,
I am using LMH6586 for my analog video switching, where I have 3 different switches for R, Gs and B. G is having embedded sync, whereas R and B don't have.
I want all (R, G and B) black level to be at 300mv, R and B…
Part Number: LMH6586 Other Parts Discussed in Thread: TMUX1134 , I would like to use this part to switch non-video analog signals around +/-400mV. Will this device work in that application to give the same output? If so, what would the setting be?
Part Number: LMH6586 Tool/software: Hi all
I am using 3 LMH6586 switches in one of my projects, which I am using to switch STANAG 3350B signals, R, Gs, and B for respective switches. All switches are configured with 2x Gain.
STANAG standard states…
Part Number: LMH6586 are GND and DVSS (digtal grounds) are isolated internally inside LM6586 chip?
we have analog and digital signals in our design. Can we use GND as analog ground?
as per our understanding
1. DVSS is a digital ground referred by…
Part Number: LMH6586 Other Parts Discussed in Thread: LMH6572 I am feeding STANAG-format single ended signal to cross point switch
Top LEVEL Block Diagram:
LMH6586.pdf
When cross point switch is in power down state, Sync and Active Video of signal…
