Part Number: LMK00306 Team,
Thanks for usual prompt support.
Please support below two inquiries from our customer,
1, Is there a problem with the following pin?
OSCin: Pin → 51ohm → 0.1u → connected to GND. OSCout: Floating(free pin) REFOUT…
Part Number: LMK00306 Other Parts Discussed in Thread: LMK62A2-200M , I have a general question regarding ac coupling your clock chips and clock buffer ICs. Using this part number for example (LMK62A2-200M to drive this part).
1. When should you ac couple…
Part Number: LMK00306 Other Parts Discussed in Thread: LMK00301 Hello team,
My customer would like to know if below connections work correctly.
OSCin: Pin. 12 > 51ohm > 0.1uF > GND
OSCout: Pin. 13 > Non connected.
REFout: Pin. 33 > Non connected…
Part Number: LMK00306 Hi,
Could you let me know about Power Supply Sequence of Vcc and Vcco, please? Which description below is correct?
-In datasheet page of 6 =>"(2) Vcco should be less than or equal to Vcc (Vcco ≤ Vcc)."
-In datasheet…
Part Number: LMK00306 Greetings,
I have some questions I hope someone could answer.
these are as follows:
* does the part support spread spectrum?
* I am using both banks but I will not be using all outputs.
what is the best way to terminate LVDS unused…
Part Number: LMK00306 Other Parts Discussed in Thread: LMK00338 Hello,
I have a customer looking for a 6 output clock buffer supporting PCIe gen 4. Although this datasheet doesn't say it does support it, I was looking through the jitter requirement since…
Part Number: LMK00306 The datasheet does not seem to include output impedance values. What is the output impedance of the drivers? I specifically need to know for the HCSL and LVDS drivers as I am implementing one bank as HCSL and the other as LVDS.
Other Parts Discussed in Thread: LMK00306 I plan to use the LMK00306 to fanout a 100MHz clock to a processor that requires 4 clocks. Two of which are required to be HCSL and the other two are LVDS. This fanout will be powered and receiving a clock before…
Other Parts Discussed in Thread: ADC07D1520 , LMK00306 Hello,
Starting from a 100MHz LVDS system clock, I'm thinking to use an LMX2541SQ3030E and LMK00306, to generate 4 x 1,500MHz LVDS sampling clocks for a module with 4 pieces ADC07D1520.
Is there…
Hi Amy,
It seems like the correct configuration may be adding the 100 ohm resistor before the ac coupling capacitors to allow for proper DC biasing, like Figure 10-11 (the one in blue) in your initial post. However, as mentioned, you would run into double…
