Part Number: LMP91000EVM Other Parts Discussed in Thread: LMP91000 Tool/software: I am using the LMP91000EVM board with a 3-lead O₂ sensor connected to it. After trying different configurations, I observed that the voltages measured from the board do…
Part Number: LMP91000EVM Tool/software: I have a new LMP91000EVM board. And I also have two old SPIO4 interface boards. Should I be able to run these together on a Windows 10 computer. When I try to install them the drivers do not want to install. If…
Part Number: LMP91000EVM Other Parts Discussed in Thread: LMP91000 Tool/software: Hi,
I am trying to build a 3-electrode chronoamperometric electrochemical system with LMP91000, driving it with an STM32WB55 board. I am able to communicate with the board…
Part Number: LMP91000EVM Other Parts Discussed in Thread: LMP91000 Tool/software: Were working on a project in which we have to implement glucose meter for which we are trying to simulate a 2 pin configuration on LMP91000, The microcontroller used is…
Part Number: LMP91000EVM Other Parts Discussed in Thread: LMP91000 Tool/software: i am using an LMP91000 model with a STM32L5 model to configure it and read the data while doing so the device status is ready but the I2C communication doesn't occur all…
Part Number: LMP91000EVM Other Parts Discussed in Thread: LMP91000 , ADC161S626 Tool/software: I'm trying to build heavy metal content on liquid with 3 leads electrode that the final result will be Cyclic Voltammetry and the concentration of the heavy…
Part Number: LMP91000EVM Hi, I am trying to connect the board to an arduino, but I can't find the pins allocation in the datasheet, can you please kindly provide me with the correct pin name/numbers for the EVM board not the chip itself.
Thanks.
Part Number: LMP91000EVM Other Parts Discussed in Thread: LMP91000 , MSP-EXP430FR6989 Does the LMP91000EVM require the SPIO4 Board? Is the SPIO4 Board shipped with the LMP91000EVM?
Thanks
Bob
Part Number: LMP91000EVM Other Parts Discussed in Thread: LMP91000 Hi,
I am trying to build an electrochemical circuit with the LMP91000. I am doing the register changes through I2C with the microcontroller and can get the ADC value from the output…
Part Number: LMP91000EVM Hi Team,
A customer is asking how to set a specific voltage (of 0.1v) between WE and RE pins, in 3-electrode measurement mode.
I looked at the datasheet section 7.3.1.6.1, it seems to be possible by adding a resistor in between…
