Part Number: LMQ61460-Q1 Hello team,
The datasheet of LMQ61460-Q1 specifies the absolute maximum spec of Min=0V for PGOOD pin. It’s not allowed to get any negative voltage, unlike other pins (Min= - 0.3V). Also, the PGOOD can be grounded if not used…
Part Number: LMQ61460-Q1 There are inconsistency between Webench sch and datasheet information. There is a RESET_N pin at Webench. However when I checked from datasheet , there is no RESET_N pin.
I think datasheet is correct but I want to be sure. Could…
Part Number: LM61460-Q1 Other Parts Discussed in Thread: LMQ61460-Q1 , LM63460-Q1 , LMQ61460 , LM61495-Q1 Hi team
I found an opportunity to promote TI 6A WV Buck to a automotive application and LM61460-Q1, LMQ61460-Q1, and LM63460-Q1 are three candidates for…
Part Number: LMQ61460-Q1 Other Parts Discussed in Thread: LM61460-Q1 Hi Team,
In LMQ61460-Q1, what value of internal capacitors at the input?
In LM61460-Q1, as these internal caps are not there, what is the value recommended for input caps to ensure similar…
Part Number: LMQ61460-Q1 Other Parts Discussed in Thread: LMQ61460 Dear
I proposed LMQ61460 as IBB for customer OLED ELVSS supply. Could you please help review below SCH? Thanks a lot!
Vin 12V, -VOUT -10V
Part Number: LMQ61460-Q1 Our schematics is nearly the same as the LMQ61460-Q1 EVM-Modul (with LMQ61460AFSQRJRRQ1). Without load output-voltage is 5.1 Volt. When we increase the load output-voltage dorps. What could be the problem?
Part Number: LMQ61460-Q1 When I make a design in WebEnch using LMQ61460AASQRJRRQ1, can I replace it with LMQ61460AFSQRJRRQ1 without changing schematics? Thanks for help, Greetings, Jean Finders
Part Number: LMQ61460-Q1
Hi,
We want to use the LMQ61460-Q1 for a 1V/2A output option , with 12V input ( it is the minimum output voltage that is possible according to the data sheet). The WEBENCH doesn't support this option ,
I receive the following…
Part Number: LMQ61460-Q1 Other Parts Discussed in Thread: LMQ61460 , We have a design generating +5V @ 4A and +3.3V @ 4A using two off LMQ61460 over -40'C to +85'C with 10V to 30V input range.
Both supplies were designed using Webbench, running…