Hi Anton,
LMR14030 is being used by worldwide automotive customers with very large volume, we don't see such complain on un-regulated output voltage so far.
can you pls send me amail at andy.chen@ti.com for more application information:
1, Vin,…
Part Number: LMR14030-Q1 Tool/software: Code Composer Studio 1. MP2229 is a chip with adjustable output and soft start time of ns. Can I use LMR14030-Q1 to replace it with PIN 2 PIN?
2. I see the soft start time of the LMR14030-Q1 in the manual is 5ms…
Part Number: LMR14030-Q1 Other Parts Discussed in Thread: LMR14030 EMI(RE) Fail and power ripple noise since EN PIN connection was changed. EN PIN changed from VCC connection to other power. The changed other power is using TPS55160QPWPRQ1 (2Mhz Fixed…
Part Number: LMR14030 Hi,
We implement power supply to convert 24V to 12V:
And at the output we get sawtooth signal with ~5V amplitude:
Please advise how we can deal with that.
Thanks in advance.
Part Number: LMR14030-Q1 Hello Team,
for worst case calculation my customer needs the gate/source charge capacity of the output MOSFET. Do we have these figures?
Many Thanks
Josef
Part Number: LMR14030-Q1 Other Parts Discussed in Thread: UC1611 , LMR14050-Q1 Hello, everyone.
I am Gabriel An, and I am planning to use LMR14030-q1 for the power, and need schottky diode for low side switch.
I looked at the LMR14030EVM guide and…
Part Number: LMR14030 Hello guys,
One of my customers is manufacturing their new products which uses LMR14030 as main power supply.
In their manufacturing, they mistook RT resistor value. The correct resistor value was 23.7kohm for 1MHz switching…
Part Number: LMR14030 hello sir,
one customer use two LMR14030 in their design, one si DV 24v to 15V, another is 24v to -15v, -15v is mark 15N, and 15V is mark 15P, in schmatic, which is for the AMP and ADC, and there are one L (L9)and C between 15N…
Part Number: LMR14030-Q1 Hi, TI Support Team
I am reviewing development using the LMR14030SQDPRRQ1 product from a customer.
Please review the circuit diagram attached below.
Please respond to any further inquiries.
1. Please explain in detail…
