Hi,
I hope i understand correctly your question. Let me know if the following answers are sufficient
1) As far as having a secondary supply in parallel with the LMR33610, it is recommended to put a diode OR at the output of the converter after the…
Hi Bhushan,
My exact requirement:
LMR33610B, VinMin = 6, VinMax=32, Vout=5, Iout=1A, Output rippleMax 75mVpp, PCB surface Temperature =70
In order to shrink the inductor and output filter i would preferre LMR33610 "B" variant.
br
Jørgen
Part Number: LMR33610 Hi Team,
Needed MOSFET specifications such
1.Rdson of Low-side and High side Switch
2.Rise and Fall time of SW node(Vin=24V Vout=5V Fsw=1.4MHz)
Thanks
Sathish
Part Number: LMR33610 Other Parts Discussed in Thread: LMR33630 , , LMR36506 , STRIKE Hello, I'm working on a design with multiple power rails and would like to use the fewest number of different parts that I can. I have some loads that are 0.5A and some…
Part Number: LMR33610 HI,
LMR33610 this part used Our design Need top and bottom MOSFET Raise , fall time for Efficiency analysis.
Please provide the Evaluation schematic for LMR33610 device.
Part Number: LMR33610 Good Afternoon,
I'm looking to choose an Inductor to be used with this part. I'm currently looking at the A variant (400kHz fsw).
Using WBench, an inductor of 15uH has been chosen; but using the formula in the datasheet it…
Part Number: LMR33610 Hi,
We have two power supply rails 5V and 6V both using LMR33610
#
Parameter
6V Supply Rail
5V Supply rail
1
Input voltage max
12.6V
12.6V
2
Typical load current
0.5A
0.3A
3
Calculated…
Part Number: LMR33610 Hi Team,
According to Table 4-6 of the SFFS006 Application Report, "Fault mode will shut device off" if the AGND pin is shorted to ground. Is this an error in the document? We have received a feedback from a customer that there…
