Part Number: LMT87 I want to accurately measure the temperature of a surface with the LMT87. To this end, it would be important to place the correct side of the sensor on the surface. The datasheet states: "To ensure good thermal conductivity, the backside…
Part Number: LMT87 Hello everyone,
What was the VDD value used to create the data in Table 3 ("LMT87 Transfer Table") in LMT87.pdf?
I do not see the value of VDD used to create the data in Table 3 ("LMT87 Transfer Table") in https:/…
Part Number: LMT87-Q1 Dear Support,
Please confirm why the marking of the middle chip is a little more inclined than the other two chips? Is this normal?
Why does the original product show such a chip marking position? Thanks
Part Number: LMT87 Other Parts Discussed in Thread: LMT84 , Hello,
I recently changed a design from the LMT84DCKT to the LMT87DCKT
However, with the LMT87DCKT I am getting an output of 887mv at 27 Celcius?
It should be 2271mv? at 27 Celcius?
The LMT87DCKT is…
Part Number: LMT87-Q1 Other Parts Discussed in Thread: LMT87 , Please tell me. I'm using LMT87 now. However, the pcb will corrode in under adverse conditions and the LMT87 will not work. In this case, is it okay to have a moisture-proof coating on the…
Part Number: LMT87-Q1 Hi,
In LMT87-Q1 datasheet, Figure 10 shows the capacitive load(Cload) should be less than or equal to 1100pF. But If the capacitive load greater than 1100pF(for example: 0.022uF) without a series resistor , What will be the impact…
Part Number: LMT87-Q1 Other Parts Discussed in Thread: LMT87 Hi,
my customer is looking for the Simulation models SPICE or IBIS for LMT87QDCKRQ1
They need simulation models for Electromagnetic Simulation of the design.
Can we support that?
Part Number: LMT87 Hi,
I am Yonghee Lee and working for LG innotek as a software engineer in motor control.
I am supposed to use LMT87 as a temperature sensor and I would like you to tell me the real maximum operating range of LMT87.
According to the…
Part Number: LMT87 I want to test a temperature sensor by heating it to 100 Celsius and above, possibly using an induction heating module.
I am concerned there may be immediate and long term negative effects on the sensor and its output signal. Can anyone…