Hi Adam,
I believe the SC70 listing on the first page of the OPA376-Q1 datasheet is a typo that was carried over from the non-automotive OPA376 datasheet. As you found in the package option addendum, we only offer the OPA376- Q1 in the SOT-23 package…
Yanagida-san,
This post also is very similar to what has already been posted:
https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1176997/lmv841-q1-failure-mode-distribution-pin-fmea
Please refer to that post for guidance on…
Hello Lothar,
I tested the TLV2254 simulation model and found that it does not work correctly when operated with a single supply; despite the the op amp being capable of powered by a single +2.7 to +16 V supply.
When I examine the model design I…
Other Parts Discussed in Thread: LMH6518 , LMV841 , LMV842 , TINA-TI Good evening,
I`ve been testing in the last couple of hours the given oscilloscope circuitry (Low Noise Amplifier + Input resitive divider) from the LMH6518 datasheet, and i obtained…
Other Parts Discussed in Thread: LMV841-Q1 , TLV197-Q1 , OPA197-Q1 , ALM2402F-Q1 , ALM2403-Q1 , OPA192-Q1 , OPA322-Q1 , OPA388-Q1 Inverter and Motor Control systems are used in electric vehicles to manipulate an AC signal with pulse width modulation that…
Other Parts Discussed in Thread: OPA735 , LMV641 , LMV841 , OPA2188 looking for OPAMP,Vcc max=12v or more,Offset=less then 60uv,Rail 2 rail,Size=SC70
I found the OPA735 which meet these4 parameters but not in SC70 package.
Other Parts Discussed in Thread: OPA335 , LMP2021 , OPA330 , OPA376 , LMV321 , OPA378 , OPA333 , LMV841 Need to replace current design with LMV321DBV (SOT23-5 package) with lower offset amp. of below o.5mV.
I found OPA335/333/376336/365,but they are…
Hi Marceli,
the output current of XTR111 must be limited to less than 50mA or you risk that the XTR111 becomes damaged. The XTR111 is not designed to output a current of 100mA.
I would think about using the improved Howland current pump:
3835.snoa474a…
Part Number: OPA547 Other Parts Discussed in Thread: TINA-TI Team,
We are using the OPA547 for an "improved Howland current pump" to turn voltage to a 0–20 mA output.
It works ok until a given input voltage level. When this input voltage is reached…
