Part Number: LMZ23608
I would like to get the junction-to-case (bottom) thermal resistance for the LMZ23608TZE/NOPB during natural convection conditions. The data sheet lists junction-to-case (top) and junction-to-ambient but does not list the junction…
Part Number: LMZ23608 I have been using LMZ23608 as voltage regulator for one year and I get very good results. I have been using a Voltage constant control mode by RFBT and RFBB, but I wonder If I could use a Power constant control mode leaving unmounted…
Other Parts Discussed in Thread: LMZ23608 , LMZ13608 , LM25116
Hello,
I search an Simple Switcher solution with Vin = 24V and Vout = 6.5V better 7V @ ~8A
For the "normal" LMZ13608 or LMZ23608 versions Vout max is defined to 6V. So I found no real…
What is the risk of running this part at 8V output? Is the part susceptible to failure? Is the compensation scheme prone to instability at voltages above 6V? We have a board running at 8V now and seems to be fine.
Other Parts Discussed in Thread: LMZ23608 , TPS2113A , LMZ13608 , TPS3700 Hello,
We are considering using two LMZ23608's in parallel (5V out), but are doing so to use them as redundant supplies (safety critical).
In the design notes the slave supply…
Hi,
I have had this problem with 2 boards, and we were using them for days before the short circuit occured.
I don't think we had any overvoltage problem since we are using a reliable AC/DC power supply for the board. I suspect overheating, but as…
Other Parts Discussed in Thread: LMZ23608 What is the actual minimum input voltage for LMZ23608\10 for the 5 volt output?
The table from the datasheet claims that the Vin range is 7-36, but when I try to start designing via WEBENCH it does not want…
Part Number: TPSM63606 Other Parts Discussed in Thread: TPSM63608 , LMZ23608 , LMZ13608 Hi TIer
My customer want choose TPSM60603 and TPSM63606 in medical ultrasound application.
But TPSM63606 can not output 0.9V voltage.
Could you help find a power…
Other Parts Discussed in Thread: LMZ23610 , LM25116 , LM5116 , LMZ23608
In the project that we are currently working, we have a requirement as shown below.
VIN = 12V, VOUT = -5.5V, IOUT = 5A
We are searching for a buck with the above given spec…
Hi Amelie,
I would not recommend doing this since there is no way to equally distribute the current loads per path. Say you had two LM73606 in parallel and pulling 12A at the connected output; one of the current paths could be pulling 8A while the other…
