Part Number: LMZ35003 Tool/software: I am building a power supply board which will use the LMZ35033 to generate 5V, 12V from +48V. Any feedback is appreciated.
Design
The only difference between the two configs is the Vset resistor (53.6K, 140K)
…
Hi Shuji,
The DNC pins (2, 3, and 25) are connected to internal circuitry yes. They must each be soldered to an isolated pad and cannot be connected to each other per Table 2 of the datasheet.
Thank you,
Joshua Austria
Part Number: LMZ35003 Hi team.
When VOUT=12V, is it possible to set Slow Start to a short time such as 7ms?
The data sheet says 17ms (SS/TR=22nF) is recommended, but why?
Part Number: LMZ35003 Hi All,
I have a question about the output ripple of the LMZ35003.
Please tell me the values of the input and output capacitors in the graph below.
Best Regards, Ishiwata
Part Number: LMZ35003 Hi All,
I have a question about slow start. It is stated that the SS pin must be open at 5V or less, but is it possible to set the SS time to 17msec by connecting a 22nF capacitor when the output voltage is 5V?
Best Regards, Ishiw…
Hello Hans,
Getting back to you a little late, but we require the receipt of purchase from authorized distributor, as well a picture of the reel to support this claim.
Part Number: LMZ35003
Hi team,
What is the minimum capacity of the output capacitor of LMZ35003?
There is a description that it is 47uFx2 of Ceramic capacitor, but if it is 10.5Vout,
the capacity reduction of DC bias is large and I do not know how many…
Part Number: LMZ35003 Hello,
We are unable to procure the LMZ35003RKGR and were wondering if the TPS84250RKGR was an acceptable alternative or if there were better alternatives TI offered.
THanks!
Adam
