Hi,
I have not heard back from you and will assume you were able to resolve the issue on your end. This thread will be closed. Reply back to this message if you still have any questions on this and the thread will reopen for further discussion.
Thank…
Part Number: LMZM33606EVM Hi, Good day. Our customer is using the LMZM33606EVM. It is stated in the datasheet that the R2 is 10kohms only. They would like to know if they can change it to other value? If yes, can you please give us the range that they…
Part Number: LMZM33606EVM Other Parts Discussed in Thread: LMZM33606 Hello,
I was wondering if you would be able to provide the Altium board layout so I would be able to use the footprint, as I am having issues designing the footprint for the LMZM33606…
Hi:
yes, your understanding is right. but in EVM layout, the noise current or voltage will not interfere the AGND, because the AGND used single -point ground way to connect the PGND at top layer, there is no way for the noise go to AGND then back to…
Part Number: LMZM33606EVM Hi,
I've bought LMZM33606EVM evaluation board. I would like to have the design source files (schematics and PCB) of this evaluation board. In the documentation page is available only a PDF.
Is there a way to get these files…
Jimmy-san, Thank you for your response and support. "I'm not familiar with the trigger timing reset. Can you explain what that is and how you got CH 3 waveform? For my setup and waveforms that I've previously sent, my oscilloscope was always triggered…
Part Number: LMZM33606EVM Other Parts Discussed in Thread: LMZM33606 Tool/software: WEBENCH® Design Tools Hi,
I have bought the LMZM33606 EVM. and make a loss analysis report. Is there anything about loss analysis you can provide to me?
Thank you
Part Number: LMZM33606EVM I've been testing this regulator (using the EVM with no modifications). My intent was to simply get an idea of the EMI profile so I could implement filtering input circuitry.
I noted that when I leave the EVM in DCM, with the…
Part Number: LMZM33606 Hi ALL, In the data sheet, the GND connected to the SYNC/MODE pin is described as AGND. However, it is PGND in the schematic (Figue6) of LMZM33606EVM.
Which is correct, AGND or PGND? Is there no problem with either?
Hi Alexander,
Though pin 14 is no connect, I'd still suggest not routing through this pin. Figure 48 in the datasheet shows a top AGND copper plane with Rt connect to the plane through a via to the bottom layer.
The team is currently working to clean…
