Hi Manivel, regarding ETSI certification I would like to add the following information. The 15.4 stack can be used with NBCN and FH mode on the ETSI regulation. Within the ETSI spec you should review the section called Adaptive frequency agility (EN 300…
The RSSI may not be valid at that point due to receiver not fulling started or populating the RSSI value.
If you read it in a while loop, you should see valid (non-127) value after short time.
Can you try waiting some delay?
Something like:
/* Submit…
Hi Albin,
I'm just following this up - it looks like it is now available on TI.com: https://www.ti.com/lit/zip/swrc391
I will mark this thread as "Resolved" as a result.
Regards,
Zack
Part Number: LP-EM-CC2340R5 Other Parts Discussed in Thread: SYSCONFIG Tool/software: I've defined a NVS section starting at flash address 0x7A000 with a region size of one sector - 0x800 bytes. Reading and writing this sector via the NVS driver is…
Part Number: LP-EM-CC2340R5 Tool/software: Hi, Ti
I need to send data through l2cap after reporting the BLEAPPUTIL_PAIRING_STATE_ENCRYPTED event.
How do I get the current channel id in app_pairing.c?
Best regards,
Preston
Hi Lawrence,
Attached is the LP-EM-CC1312PSIP layout converted to Altium format: /cfs-file/__key/communityserver-discussions-components-files/156/LP_2D00_EM_2D00_CC1312PSIP_5F00_Altium.zip
Regards,
Zack
Part Number: LP-EM-CC1354P10 Other Parts Discussed in Thread: CC1354P10 , CC2430 , CC2530 , CC2531 , CC2533 , CC2540 , CC2544 , UNIFLASH Tool/software: Hello,
I read that the packet sniffer 2 software contains the firmware that enables CC13xx launchpads to be…
Part Number: LP-EM-CC1354P10 Other Parts Discussed in Thread: WI-SUN Tool/software: Hi,
How can I perform a CoAP GET request from node to border router and use the value sent in response?
I have already seem the Training example about sending a POST from…
Part Number: LP-EM-CC2340R5 Other Parts Discussed in Thread: CC2340R5 Tool/software: The west command to compile sample project works for CC2340R52 (36KB RAM) but we want to use the CC2340R53 (64KB RAM).
The project used is the peripheral_hr
We followed…