Search tips
Showing 276 results View by: Thread Post Sort by

  • LP2951-N: LP2951ACMX/NOPB shutdown pin connection

    TI Thinks Resolved
    Part Number: LP2951-N Hello , Is LP2951ACMX/NOPB same as LP2951-N right? As per datasheet, We have two statements for shutdown pin connection which is present: 1. Here it says if shutdown pin is low , it turns off the regulator. 2. Here it says, Low is…
    • Answered

  • LP2951-Q1: Unused open-collector ERROR pin - Configuration

    Resolved
    Part Number: LP2951-Q1 Hi Team, The ERROR pin is open-collector and if unused, its OK to leave it floating as per datasheet. We would like to avoid floating nodes in our board, as it could be a potential antenna for EMI. Thus, is it OK to connect the ERROR…
    • Resolved
    • Answered

  • LP2951: Difference between LP2951DR and LP2951-50DR

    Resolved
    Part Number: LP2951 Hi team, What's the difference between LP2951DR and LP2951-50DR? Can we use LP2951-50DR to output adjustable votlage? Thanks! Nison
    • Resolved

  • LP2951: LP2951 specific ESR requirements.

    Part Number: LP2951 In the datasheet of the LP295X, there is a link on page 18 : For specific ESR requirements, see Typical Characteristics. But in the typical characteristics, there is no graph for the specific ESR requirements. Can you provide a graph…
    • Answered

  • LP2951: Obsolescence

    Resolved
    Part Number: LP2951 Dear Madam, dear Sir, could you please tell me if the following part is still available and if there is any risk of becoming obsolete in a close future? LP2951 Thank you Best regards Benjamin Cella
    • Resolved

  • RE: LP2951-N: Trying to figure out the correct max Tj

    Hi Tim, Sorry for the delay. The device in question is a 125C device. Regards, Nick
    • Answered

  • LP2951: Start up simulation at webench

    Resolved
    Part Number: LP2951 Hello team, The VOUT is not reached to set level, when simulating start up behaivor at WEBENCH. Is it possible to extend the time axis? The configuration as below, and I have created URL for my WEBENCH design. VIN: 24V VOUT: 13V IOUT…
    • Resolved

  • LP2951: Do not understand behavior when simulating ?

    TI Thinks Resolved
    Part Number: LP2951 I'm trying to cut the load with a PMOS FET using the error pin. All my attempts to simulate this result in the output (Vout) of the LP2951 going to 0V. I would expect it to oscillate between on/off. Is it my design and understanding…
    • Answered

  • LP2951: LDO recommendation

    Resolved
    Part Number: LP2951 Other Parts Discussed in Thread: TLV709 , TLV760 Hi team, Could you please recommend a device with below spec requirement? Vinmax>25V Vout=15V Iout>=100mA enable low cost
    • Resolved

  • RE: LP2951: Part number difference

    Hi Andres , Thank you for your reply, TPS7B is SOIC, LP2951ACMM is VSSOP. i have been clicking on "Notify Me" since Feb 2023 until now and i still do not get any feedback or any kind of indication whatsoever. that service i feel is unacceptable…

Didn't find what you are looking for? Post a new question.