Part Number: LP2951-Q1 Other Parts Discussed in Thread: LP2951 Hi TI Team, Good morning. Can you please confirm if the manufacture part number LP2591-50-Q1 part is different from LP2951-50-Q1? Regards, Vamsi Bankuru
Part Number: LP2951-Q1
Hi,
Customer asked about ERROR / SHUDOWN pin.
Err pin is Low Active and should I control Shutdown with this signal or is it working separately?
Schematic to use the Err/Shutdown function.
Shutdown Control with Err Pin
Shutdown…
Part Number: LP2951-Q1 Other Parts Discussed in Thread: LP2951 Hello,
Good day, Customer have a problem in LP2951, when they give a 5V on output they found there is a -5V on input. they want to know why could this happen.
Part Number: LP2951-Q1 Hi Team,
The ERROR pin is open-collector and if unused, its OK to leave it floating as per datasheet. We would like to avoid floating nodes in our board, as it could be a potential antenna for EMI.
Thus, is it OK to connect the ERROR…
Part Number: LP2951-Q1 Other Parts Discussed in Thread: TLV767-Q1 Dear sir,
Would you please help confirm whether the WSON-8 package is the step-cut package, same as the following picture?
Regards,
Jack
Part Number: LP2951-Q1 Other Parts Discussed in Thread: LP2951 , LP2951-N What happens if I leave the shutdown pin floating? Does it have an internal pull down resistor?
Other versions have that, for example the datasheet for LP2951 from Microchip shows…
Part Number: LP2951-Q1 Other Parts Discussed in Thread: LP2951 Hi team ,
Our design used the " LP2951-50QDRGRQ1 " IC ,
I downloaded the spice model from site , our Design is providing gate supply to the IGBT driver ,
For low side IGBT , emitt…
Part Number: LP2951-Q1 Other Parts Discussed in Thread: TCAN4550-Q1 Hi
The start up output waveform and schematic are as below, the spike is up to 6V, the capacitors are all ceramic but we have tried adding 1Ohm resistors, and disconnected the load, the…