Part Number: LP2992 Tool/software: Hello,
my customer is experiencing some malfunctions on a product that is based on LP2992, SOT23-5 package. I noticed today that it has been introduced a new version with a significantly lower threshold on the ON/OFF pin…
Part Number: LP2992 Tool/software: Hello,
For the LP2992 (specific part being used is LP2992IM5-3.3/NOPBCT-ND), the datasheet specifies that an output capacitor with low ESR is required, but there are no specific limits specified.
Would Samsung CL21A106KOQNNNG…
Part Number: LP2992 LDO team,
The LP2992 is available in a new process according to the datasheet. Page 29 of the datasheet says the orderable should have an M3 at the end to indicate that you are ordering the new chip. Yet, when you look at ti.com or…
Part Number: LP2992 Hi，
The theoretical output of LP2992M5-3.3/NOPB is 3.3V, and individual output of the customer's circuit board is 1.5V. On the schematic diagram, the C15 capacitor was removed and resoldered, and the normal output of 3.3V can be restored…
Part Number: LP2992 Hi,
I'm suddenly seeing strange behaviour on the LP2992 devices. Applying vinput of 3.7v , when on/off pin is tied low, device should be off right?
I'm getting 3.3v output no matter what I do with the on/off pin.
This is…
Part Number: LP2992
Hi,
We have tested a circuit that takes a 10s cell pack which idles at 42V full charge and is connected to a LV2862Y dc dc converter to make 12V from the cells. We also have an LDO at the 12V which generates 5V and is connected to…
Part Number: LP2992 The December 2023 revision (K) of the LP2992 datasheet introduced a 'new' and a 'legacy' version of the device. There is a table in the datasheet which describes the difference in part numbering, but the part numbers in the…
Part Number: LP2992 Production of LP2992AIM5X-1.8/NOPB is scheduled to be discontinued, but will production of LP2992AIM5-1.8/NOPB continue in the future? It's still in active status on TIstore.
Hi Kelsey,
as we have not received an additional information, I assume this issue is solved and I am closing the thread. If there is still something open, just reply to open it again or open a new thread.
Best regards, Stefan
