Part Number: LP3944 Hi,
Good Day. I have a customer who is working with LP3944. Please see below his query for your reference. Thank you very much.
The issue is the LP3944 driver which engineering wise we cannot resolve given the spec sheets.
The question…
Part Number: LP3944 Other Parts Discussed in Thread: TLC59116 , LP5861 ,
It is advised that each LED connected to this driver IC should not exceed 25 mA current draw. is this average current or peak current rating? most LEDs have peak currents much higher…
Part Number: LP3944 I'm using the above part in my design and would like TI to review the design. I prefer email or personal messages instead of sharing in the forum.
Part Number: LP3944 Other Parts Discussed in Thread: LP5569
am trying to follow this example
Programming Example:
Dim LEDs 0 to 7 at 1 Hz at 25% duty cycle
1. Set PSC0 to achieve DIM0 of 1s
2. Set PWM0 duty cycle to 25%
3. Set PSC1 to achieve DIM1 of…
Part Number: LP3944 Dear team
There is a good news that we design in LP3944 in customer's new project.
Could you help to review the schematic?
Many thanks
Denny
Part Number: LP3944 Hi
i have received LP3944 Evaluation kit but i am unable to install the PC software. i am using window 10 machine.
i tried to look for the LP3944 PC software online but didn't ind one.
secondly the board comes with LPT connector…
Part Number: LP3944 Hi
I have got LP3944 evaluation kit but the evaluation software is not compatible with window 7 on words.
i am trying to control it via Arduino Mega but i am not unable to establish comms.
i have set the address pins low logic low…
Part Number: LP3944 Hi
we are planning to use LP3944 led driver for our new project and i have EVAL board for it but i came across END OF LIFE for the EVAL board on Mouser website
Just want to confirm whether LP3944 is approaching End Of Life. Is it ok…
Part Number: LP3944 Hi team,
my customer is asking where the thermal pad should be connected, as there is no statement in the datasheet.
My advice was, that the thermal pad is not connected and may be left open or may be connected to ground. Was that correct…