Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.



Search tips
Showing 72 results View by: Thread Post Sort by

  • LP5012: Output to drive mosfet -> 12v led strips

    Part Number: LP5012 Tool/software: Im a software guy, who knows little bit of electronics... i want to use the LP5012 to drive 12V RGB LED Strips the led output is duped for out1 and out2 of course to get RGB set in the image this is my design, it works…
    • Answered

  • LP5012: How to connect 24V RGB leds strip to LP5012

    Resolved
    Part Number: LP5012 Other Parts Discussed in Thread: TLC59116 Tool/software: Hi the community, We have a stock of LP5012 (from another project). I'd like to drive a RGB leds strip with this chip for a new project. The problem is that the RGB leds…
    • Resolved

  • LP5012: Support is needed

    TI Thinks Resolved
    Part Number: LP5012 Tool/software: Hello, im working on an IOT device that combine an MCU and a LP5012 LED driver. my purpose is to run an LED driver on a constant current of 20 mA i have create the following circuit using LP 5012 when trying to communicate…

  • LP5012: Multi LEDs turn on simultaneously

    TI Thinks Resolved
    Part Number: LP5012 Tool/software: Hi team, Can LP5012 turn on multi LEDs simultaneously? Customer tried it but couldn't it. Is this due to of Phase-Shifting function? Best regards, Goto
    • Answered

  • LP5012: Delay is observed when individual LEDS are turned ON simultaneously using I2C command

    Resolved
    Part Number: LP5012 Tool/software: Hi Team We are using LP5012 LED Controller, where a visible delay is observed when individual LEDs are turned ON using I2C command as below i2c mw 0x14 0x15 0xff; i2c mw 0x14 0x13 0xff; i2c mw 0x14 0x11 0xff; i2c mw 0x14…
    • Resolved
    • Answered

  • LP5012: 5V to VCC pin ok

    Resolved
    Part Number: LP5012 Hello I just want to confirm this is acceptable and correct: Going to use LP5012 in a design where the I2C is shared between different slaves ( addr. is different ), the pull up resistors for SCL and SDA is connected to 3.3V. LP5012…
    • Resolved

  • LP5012: LED Driver Support

    TI Thinks Resolved
    Part Number: LP5012 Other Parts Discussed in Thread: LP5009 Hi Team, We are using LP5012RUKR LED driver interfaced over I2C interface. Could you please share the Linux kernel driver for the same. Thanks & Regards, Anush
    • Answered

  • LP5012: Alternative device with temperature up to 125C

    Resolved
    Part Number: LP5012 Other Parts Discussed in Thread: LP5018 , LP5860 , TLC5940-EP Hi, my customer is using LP5012, but they would like to have some more headroom in terms of ambient temperature. LP5018 product page mentions up 125C, but it is actually T…
    • Resolved

  • LP5012: I2C communication SDA signal fault at ACK bit level

    Part Number: LP5012 Hello, We have designed an electronic board to control RGB LEDs using the LP5012 LED driver. To test our board, we use an Arduino Nano acting as a master communicating with the LP54012 slave present on our board. We noticed a fault on…

  • LP5012: Power design

    TI Thinks Resolved
    Part Number: LP5012 Could you please suggest a recommended switching frequency for the power regulators to be used with this part

Didn't find what you are looking for? Post a new question.