Part Number: LP5012EVM Other Parts Discussed in Thread: LP5012 Hi Expert,
My customer has an issue about unstable Duty at low brightness setting.(with LP5012)
Left side in the following waveform is set Brightness value to 64. If they set over 64…
Part Number: LP5012EVM Other Parts Discussed in Thread: USB2ANY , , LP5012 Team, Customer tries to connect to the http://www.ti.com/tool/LP5012EVM using USB2ANY. -Specifically about the LP5012EVM GUI: Trying to connect to the EVM: - PC runs Win 8.1 -…
Hi Kazuto,
I'll close this thread temporarily and you can update your customer feedback under this thread. The thread will be opened again if you update any latest progress and I will reply to you. Thanks.
Part Number: LP5012EVM Other Parts Discussed in Thread: LP5012 Even I set the registers as below, the LED sink current stays @ 20mA and never goes up to 35mA.
40 1E 0F FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF 00
I supplied 3.6V…
Part Number: LP5012EVM Other Parts Discussed in Thread: LP5012 , USB2ANY The installation and use of the last version of the software hadn't solved the issue.
(see https://e2e.ti.com/support/power-management/f/196/p/870845/3228404 )
Best Rega…
Part Number: LP5012EVM Other Parts Discussed in Thread: LP5012 , USB2ANY
Team,
Using the LP5012 with USB2ANY and LP50xx GUI SW : -The latest GUI SW is used (taken from this E2E post ). -The USB2ANY firmware update has been done.
The GUI does not…
Part Number: LP5012EVM Other Parts Discussed in Thread: LP5012 LP50 EVM s/w is sending wrong I2C address to the EVM. It makes not possible to communicate with EVM board.
In the datasheet, I2C address of Lp5012 is 00101XX. If I set 00 for ADDR selection…
Part Number: LP5012EVM Other Parts Discussed in Thread: USB2ANY Hi,
any action using the LP5012EVM's GUI has no effect except a temporary message in the bottom left of the window "Couldn't update register xxxx" (with xxxx according to the setting I…
Part Number: LP5012 Tool/software: Hello,
We are currently using your LP5012 driver on our devices which so far have always worked well. However, we found ourselves in the situation of having to use 4 LP5012 drivers on the same I2C communication line…
