The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: LP5866 Tool/software: Hi Team,
I can see we can change the PWM duty by setting pwm_bri* regisiter for each dots.
Is there any procedure to set 8-bit or 16-bit? or It's only set pwm_bri*?
e.g. to set L0-CS0 as 8-bits PWM, we need to…
Part Number: LP5866 Tool/software: Dear TI team,
Handling the Unused VSYNC Pin on the LP5866 Should the pin be left open (floating) or connected to GND?
I would appreciate your guidance on this matter.
Best Regards,
Taroimo
Part Number: LP5866 Tool/software: dear T.I.
I have some questions about the output current of the LP5866.
What is the maximum current output from one SW pin of LP5866?
Is it possible to output 550mA from a single SW pin?
Part Number: LP5866 Other Parts Discussed in Thread: USB2ANY Tool/software: Hi TI Team，
Customer installation NVC245-LP586x family Graphical User Interface Matrix LED driver installation failed,
There are the following prompts, thanks.
Part Number: LP5866 Tool/software:
Q1:How long after power-on should EN=H be set?
Q2:What is the time between sending software reset RESET=FF and STANDBY?
Q3:Is there a power off sequence?
Hi Masashi,
The steps above should be correct. There are several questions below may need your help to answer for further analysis.
The communication is successfully (has ACK from LP5866), correct?
For the step 2, the data 0x30 should be wrote to register…
Hi Ohashi,
Please refer the thermal info of LP5866 first, since LP5866TSSOP and LP5862TSSOP have the same package. We will fix the LP5862 datasheet ASAP.
BR, Jared
Hi Steven,
We do not have p2p solution with AS1117. I do not think TLC59482 can be used in it. For such 8x8 display segment, you could take a look of LP5868 or LP5866.
