Part Number: LP5907-Q1 Tool/software: Hi，
Question 1: What is the internal working principle of LP5907-Q1 overheat protection? How much temperature will burn out? What is the recovery mechanism after overheating protection?
Question 2: What is the…
Part Number: LP5907-Q1 Tool/software: Hi all,
About internal MOSFET Structure of this device,
1) Is this MOSFET a high-current power MOSFET?
2) Is this MOSFET a vertical structure or horizontal structure?
I think it is not power MOSFET because…
Part Number: LP5907-Q1 Hello Team,
Question 1:
Could you please mention the possible "resistance value" between IN and OUT pin?
this is needed to calculate the possible inrush current in my system ( with certain Vout and Cout values). Also i need…
Part Number: LP5907-Q1 Other Parts Discussed in Thread: LP5907 , TPS7A21-Q1 , LP5907 Q1 has max output cap limitation of 10uF. is it allowed if i have high value of capacitor spread at longer distance from LDO output?
is there any guideliens regarding…
Part Number: LP5907-Q1
Hello,
the datasheet shows the inrush current value graph:
How do we say that how much inrush current is acceptable to LP5907Q1?
i am referring to "Figure 8. Inrush Current".
Also could you please share me the dynamic…
Part Number: LP5907-Q1 Other Parts Discussed in Thread: LP5907 , TPS7A20 Tool/software: Hi LDO Team，
I notice there is a link about LP5907-Q1 output capacitor should be less than 10uF:
https://e2e.ti.com/support/power-management-group/power-management…
Part Number: LP5907-Q1 Other Parts Discussed in Thread: TINA-TI , TPS7A21-Q1 , LP5907 Dear team,
My customer is evaluating LP590718QDQNRQ1 for their system and have 2 questions. Can you help me to support them?
1. Are there minimum load current requirement…
Part Number: LP5907-Q1 Hi,
I have clients who use this LDO to design circuits with undercharge phenomena.
The front-end DCDC is 12V to 5V. There is no overshoot during power-on. Only LDO output overshoot occurs.
The schematic design and waveform…
Part Number: LP5907-Q1 Hi team,
could you help on the following questions:
Time required for current/temperature detection,（ this is the time from the temperature (current) anomaly to the shutdown of the output ）
Whether the test is determined…
