Part Number: LP5912-EP Other Parts Discussed in Thread: LP5912 Tool/software: Hi,
I notice the datasheet for this part stipulates a maximum output capacitance of 10uF. Is this the max. value of the output capacitor connected directly on the output,…
Part Number: LP5912-EP Tool/software: From one day to the next, the voltage regulator I was using developed a low impedance (16ohms) between pins 4 and 5 on the WSON package. As EN was also tied to the Vin, this caused the supply for the circuit to go…
The on-board Ethernet debugging has the following problems: the network card can be identified, but the PING is different and the network cannot be connected,Test data and SCH see attachment.
test data.docx 1537.TBOX DP83TC811S-Q1 SCH 元征.pdf
Part Number: DP83867IS
Tool/software:
Hello,
I am working on a custom board that uses the Zynq UltraScale+ MPSoC and the DP83867 PHY for Ethernet communication in SGMII mode . However, I am encountering issues where the PHY is not being properly…
Hi Balvan,
Yes, this should be stable since the 100 ohm resistors are acting to isolate the capacitive loading of the ADC from the amplifier (too much capacitive loading on the amplifier output will cause oscillation. See this article - Why Op Amps…
Hi Pieter,
I see you've come across the collector's edition of the ADC3660EVM = )
In all seriousness, my apologies for the inconvenience/confusion. The schematic that reflects the board that you have in hand is attached.
6840.DC104C(001)_Sch.pdf…
HI Matti,
DC104C(001)_Sch.pdf DC104C(001)_Assy.pdf
Attached are the correct schematics and assembly file for the ADC3643EVM that you have. Apologies for the confusion.
Best Regards,
Dan
