Part Number: LP5912-Q1 Other Parts Discussed in Thread: LMR43620 , Hello team,
Can you teach me for SN29500 component type of this device?
For example LMR43620 datasheet, there is mentioned in Pin FMEA document.
Regards,
Youhei MIYAOKA
Part Number: LP5912-Q1 Other Parts Discussed in Thread: LP5907-Q1 , LP5907 , TPS7A21-Q1 , LP5912 Dear team,
It is similar question of e2e below, but it is for LP5912-Q1. https://e2e.ti.com/support/power-management-group/power-management/f/power-management…
Part Number: LP5912-Q1 Other Parts Discussed in Thread: TPS7A21-Q1 , TPS7A20 Tool/software: Hello,
I'm planning to use a LP5912-Q1 (3.3V variant) in a SIL-2 system.
For my documentation I need to calculate the absolute min/max output voltage under…
Part Number: LP5912-Q1 Other Parts Discussed in Thread: LP5912 Hello E2E Experts,
Good day.
We are using the LP5912Q3.3DRVRQ1 but there are some serious issues. The IC shorts to ground during start up.
Nominal load is less than 100mA. System works…
Part Number: LP5912-Q1 Hi Expert,
I see in LP5912-Q1 datasheet that "This device is available with fixed output voltages from 0.8 V to 5.5 V in 25-mV steps.". Does it mean that LP5912-Q1 has 0.8V, 0.825V, 0.05V......5.45V, 5.475V and 5.5V output voltage…
Part Number: LP5912-Q1 Other Parts Discussed in Thread: LP5912 Hi,
Is this part susceptible to latchup?
Do you have or aware of radiation test data (SEE, TID)
Is the part bipolar technology
Part Number: LP5912-Q1 Hi,
Good Day.
In the datasheet for this part, it states on Page 5 that the dropout voltage is not a valid condition for output voltages below 1.6V. Since this part is a fixed output LDO of 1.1V, what does this note mean? …
Part Number: LP5912-Q1 When using this chip LP5912-Q1 to reduce voltage from 3.3V to 1.8V and 1.5V, what should be set respectively?Is there a reference circuit?
Part Number: LP5912-Q1 Other Parts Discussed in Thread: TPS745-Q1 Hi Sir,
The bonding wire material of LP5912-Q1 is PCC wire (based metal is Copper but with Gold and Palladium coating).
My customer is asking that if the bonding wire is Copper, there…
