Search tips
Showing 5 results View by: Thread Post Sort by

  • LP87330Q1EVM: [urgent]

    TI Thinks Resolved
    Part Number: LP87330Q1EVM Hi thanks for kindly guide. it's very helpfull to me. but I check result is, For 2phase, 1single out 1) if R3 (V1_Vout line to FB1 pin) open & R2(GND line FB to FB1pin) short = in operating SW V1 is latch-up as not enabled…

  • LP87330Q1EVM: [urgent]How can I 2phase, single out setting ?

    Part Number: LP87330Q1EVM Other Parts Discussed in Thread: LP8733-Q1 I already posted question about LP87330Q1EVM BD. but not yet, No posted and any reply. questions are how can I operating 2phase - 1out (using only V0) setting ? please let me know…
    • Answered

  • RE: LP8733-Q1: How can customer to configure the chip before they weld the chip on their board?

    Resolved
    Hi Nick: Could customer use EVM's IIC(LP87330Q1EVM) to configure LP8733-q1(OTP) firstly and weld their boards secondly?

  • RE: LP8733: Dedicated writer for writing programs

    Hello Hiroyuki, By writer do you mean some hardware solution? You can use any I2C controller (USB2ANY, Aardvark) to write the registers. Or you could use LP8733 EVM: https://www.ti.com/tool/LP87330Q1EVM Thanks. Regards, Tomi Koskela

  • RE: LP8733: Writing to the register of LP873347RHDT

    Hello Hiroyuki, First of all I hope you have noticed that it is only possible to change register (volatile) values in LP873347RHDT, and not the non-volatile memory content. So basically you need to have uC in the system that would load the values…

Didn't find what you are looking for? Post a new question.