Part Number: LP87524J-Q1 Tool/software: Hi,
I am using LP87524J device for my project. After applying 5V it is not powering ON. I have attached the schematic for your referenec.
I need your support to solve the issues.
Thanks,
Sankar.K 06. Connector…
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: PSPICE-FOR-TI Tool/software: Hi there,
I need LP87524J-Q1 spice simulation model for SI-PI analysis. We received encrypted Spice model of the LP87524J-Q1 which I have attached below, however…
Part Number: LP87524J-Q1 Tool/software: Hello,
I would like to inquire about the placement order of the PMIC input capacitor.
Due to PCB space constraints, we proceeded with the artwork as shown in the attached diagram. The decoupling capacitor (DECAP…
Part Number: LP87524J-Q1 Tool/software: Hi TI team,
1.Could you please provide LP87524JRNFRQ1 Poisson 's ratio?
2.And please provide the following parameters of pins' meterial:
1.Elastic modulus 2.Poisson's ratio 3.Density 4.Coefficient of linear…
Part Number: LP87524B-Q1 Other Parts Discussed in Thread: LP87524J-Q1 Tool/software: I'm working with the LP87524J-Q1 PMIC and trying to enable BUCK0 by applying 5V directly to the EN1 pin, without using I2C communication. However, I am not observing…
Part Number: LP87524J-Q1 Tool/software: On all devices LP87524J-Q1 I am metering a short circuit (0.0 Ohm) between pin 12 (SW_B1) and pin 13 (VIN_B1). For this behavior I do not have any explanation. The supply voltage must never be immediately connected…
Part Number: LP87524J-Q1 Tool/software:
Q1. VANA: When inputting 5V, should I pull up to 1.8V when using High Speed (3.4Mhz) mode? Can I pull up to 3.3V in Fast mode (100kHz, 400kHz, 1Mhz)?
Q2. Or, should I change the VANA input voltage value to…
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: AWR1843AOP Tool/software: Hello TI Team,
We are developing a custom board using LP87524J-Q1 to power an AWR1843AOP radar chip. The datasheet mentions that BUCK0 is 3.3V, BUCK1 is 1.2V, BUCK2…
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: IWR6843AOP , I delevop a PCB with IWR6843AOP a I want to use LP875224J-Q1 to power it without I2C communication. The schematic are the following
I have the following question about this IC…
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: AWR1843AOPEVM Tool/software: Hello,
I have a question about the schematics of AWR1843AOPEVM(PROC106B).
1) There is PMIC (U1; LP87524JRNFRQ1) on the EVM board.
The rare resistance value (4…
