Part Number: LP87524J-Q1 Other Parts Discussed in Thread: IWR6843AOPEVM , According to the datasheet the default output voltage at the SW_B3 is 2.3V? Is that correct? (Page 44 BUCK3_VOUT = (0xCA-0x9E)*0.02V + 1.42V)
Schematic of IWR6843AOPEVM Rev F…
Part Number: LP87524J-Q1 PMIC [LP87524J-Q1] OTP configuration for Function PIN - ENx (GPIOx)
I have the following questions to ask:
1) Register "EN1_PD, EN2_PD, EN3_PD": Set the pull-down resistor to enable or disable.
[Q1] Does this setting…
Part Number: LP87524J-Q1 Hi Team,
There is a good new that we could DIN TI product!
If LP87524J-Q1 Vin is 3.3V ,could SW0 have 3.3V output?
Or will have min 0.5V drop for Vin vs. Vout? THX
Part Number: LP87524J-Q1 Hi
I can not find the value of the CLKIN pulldown in the datasheet ( SNVSAW2B ) in case it is enabled. Can you share? Is it like the ENx 500k or more like the NRST 650k-1700k
Thank you.
Hi ,
Deca YJ SU said: [Q1-0] Is there any mistake in the above understanding?
Your understanding is correct.
Deca YJ SU said: [Q1-1] After these two pins are set as GPIO, if logic control is required, who is the master controller? (Is it PMIC?)…
Part Number: LP87524J-Q1 Hi,
I would like to ask you about Spread Spectrum on the LP87524J-Q1 device. When I check the default setting of LP87524J-Q1, it is set to Spread Spectrum function "Disabled". Is it possible to purchase a product with Spread…
Part Number: LP87524J-Q1 Hi,
Such as the SCH below If I want to directly input 3.3V to LP87524J, and only enable 1V, 1.2V, 1.8V output, how can I change it without affecting the output of PGood? THX
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: AWR1642 Hi Expert,
My customer design AWR1642 with LP87524J .
Is there any PMIC solution don't have to use snubber?
Thanks
Daniel
