Part Number: LP87524J-Q1 Other Parts Discussed in Thread: LP87702 Tool/software: WEBENCH® Design Tools Dear Sir/Ms.
My customer using PSpice for TI: Version 17.4 reported that LP87524 cannot simulate startup and transient. I asked him to reconfirm his…
Part Number: AWR1843 Other Parts Discussed in Thread: LP87524J-Q1 , AWR1243BOOST Hello,
This is reference to the document swra577a.pdf, Fig No. 3-2 (Open the below link). Here BUCK0 Vout providing 3V3 is used as power good signal where as the PGOOD…
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: AWR1843 Hello!!
I am considering the LP87524J-Q1 to power an AWR1843 radar. In this case, I need 3.3V, 1.8V, 1.2V and 1.1V. Reading the component datasheet I can see that the voltage for each…
Part Number: LP87524J-Q1 Hi Team,
I can see "INT_GPIO" register name at Table 5. on D/S. However there is no "INT_GPIO" at Register map. Is that right register name?
Regards,
Kotaro Yamashita
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: AWR6843AOP Hi , I'm searching for a PMIC replacing with LP87524J-Q1 because it is out of stock and mouser will expected this PMIC for 7 month or more later.
Do you have any suggestion? which…
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: IWR6843AOP Hello, customer uses the LP87524J-Q1 on their HW to power the IWR6843AOP. The Buck0 outputs 3.9V instead of 3.3V. This is same behaviour on 5 other PCBs. When connecting a parallel load…
Part Number: LP87524J-Q1 Other Parts Discussed in Thread: IWR1843 Hi Team,
We use LP87524JRNFTQ1 for powering IWR1843 radar.
For last year we have a lot of power supply failures.
The most common reason is the failure of one or more LP87524 channels…
Part Number: LP87524J-Q1 Hi,
customer need to select a PMIC, I recommend the LP87524J , one quesiton is what's the DVS control mode? is it use PWM?
do you have other recommendation that DVS is control by GPIO?
the requirements below:
need 3 channel…
