Part Number: LP8758-E3 Other Parts Discussed in Thread: LP8758-E0 , LP8758-EA Tool/software: Hello,
I'm looking at the LP8758-E3 to use as a quad output module. I need 1.2V, 1.8V, 2.5V, and 3.3V with Vin at 4V. Max current is approximately 3.2A on one…
Part Number: LP8758-E3 Other Parts Discussed in Thread: LP8758 , LP8758-E0 , LP8758-EA , TPS6521905 Tool/software: The LP8758-E3 initial voltage tally is almost perfect for our app: VOUT defaults: VOUT_0: 0x39, 900mV VOUT_1: 0x75, 1200mV VOUT_2: 0xB1…
Part Number: LP8758-E0 Other Parts Discussed in Thread: LP8758-E3 , Tool/software: Hello,
My customer is looking into using either the LP8758-E0 or LP8758-E3 in their optical transceiver modules.
If you have a comparison table showing the item-by…
Part Number: LP8758-E3 Hi team,
During the start-up period, from powering VANA to output enabled, will the Vout-pin stays 0V? Or, will Vout-pin have small but positive/negative voltage?
Below is for your reference.
Best regards,
Kurum…
Part Number: LP8758-E3 Other Parts Discussed in Thread: LP8758-E0 Since the current capacity is insufficient in one output port of lp8758-E3, I want to connect it in parallel, is it possible?
Part Number: LP8758-E3 Dears
We need a PMIC to power supply Longson 2k1000.
I found the LP8758-E3 is suitable choose. But I want to able and disable the EN1/EN2 with hardware control. May I add the load switch? How to achieve it? Which load switch…
Hi,
The output voltage of LP8758-EA can be modified by writing to the BUCKx_VSET register of the respective buck converter via I2C. However, this setting will reset back to the default 800 mV upon power cycle (on & off).
For the default value to be…
Part Number: LP8758-E0 Other Parts Discussed in Thread: LP8758-E3 , , LP8758-C5 , LP8758-C3 LP8758-E0 is a four-phase BULK. Can we connect two phases of LP8758-E3 to meet the demand of 8A current in use?
What is the difference between LP8758-E3 and…
Hello Leon,
1. The output voltages you listed matches with https://www.ti.com/product/LP8758-E3 ? Are those the samples you are testing?
2. Yes floor voltage settings need to be written once the device is powered on.
3. Yes they can write new…
Part Number: LP8758-E0 Other Parts Discussed in Thread: LP8758-E3 Hello
our customer use LP8758-E3 , Vin=3.3V； Vout0 =0.9V, when the output current changes from 1.5A to 1.8A suddenly, the Vout0 changes from 0.9V to 0.83V.
is there any suggestions…
