Part Number: LP8863-Q1 Hi Staff
Are the DAP (pin 39), PGND (pins 11, 12), ISNSGND (pin 13), and GND (pin 38) connected internally within the device?
regards
cafain
Part Number: LP8863-Q1 Tool/software: Hi,
I’m using the LP8863-Q1 LED driver via I²C in a Zynq based embedded system. The initial configuration and LED control works correctly after power on.
However, if I reinitialise the device in software (without…
Part Number: LP8863-Q1 Hi Experts,
I needed a clarification.
Suppose 3-channels are in cluster mode and the other three are in display mode. Can I connect all to the boost voltage ?
In the older LP8860, this was explicitly forbidden :
Does the…
Part Number: LP8863-Q1 Other Parts Discussed in Thread: LP8866-Q1 Hi Team,
That is ok to reset all fault REG with EN pin to LOW? or it needs VDD POR?
If that support via EN pin toggling as soft resest, it doesn't need Power reset as well.
Please…
Part Number: LP8863-Q1 Hi,
I’m using the TI LP8863-Q1 and I want to confirm whether register writes made over SPI/I2C are retained after a power cycle.
From reading the datasheet, it looks like:
the device loads EEPROM default/trim values at…
Part Number: LP8863-Q1 Other Parts Discussed in Thread: LP8553 , Tool/software: Thank you for your business. We are currently designing an LED backlight control circuit using LP8863 Q1.
We are investigating the response delay until the luminance actually…
Part Number: LP8863-Q1 Tool/software: Hi experts,
It is planned to use the LM8863-Q1 as a driver for LED strings. This should be placed near a GPS antenna.
Are there any test reports or design recommendations regarding the EMI/EMC characteristic…
Part Number: LP8863-Q1 Other Parts Discussed in Thread: LP8868Y-Q1 , TPS923654 Tool/software: Hello Ti Support,
I am using the LP8863-Q1, Sepic configuration, with coupled inductors.
Do I need a Poly Capacitor with Resistor in parallel with the…
