Part Number: TMDXIDDK379D Other Parts Discussed in Thread: LVSERVOMTR Hello team,
If I use TMDXIDDK379D for driving low voltage motor such as LVSERVOMTR , are there any concerns?
Any samples would be appreciated.
Thank you.
Part Number: LAUNCHXL-F28379D Other Parts Discussed in Thread: C2000WARE-MOTORCONTROL-SDK , C2000WARE , BOOSTXL-POSMGR , , LVSERVOMTR , LAUNCHXL-F280025C Hello team ,
I c onsider introduction of motor control development kit for TMS320F2837xD .
Now, I only…
Hi Chris,
I reviewed a previous post to look for some solution.I saw you have said LVSERVOMTR is salient, but I find its Ls-d and Ls-q are the same in user.h . I feel confused. Can you help me?
Thanks.
Other Parts Discussed in Thread: LVSERVOMTR , MOTORWARE , DRV8301 Hi,
I got parameters of LVSERVOMTR in its datasheet except rotor flux.It's neccessary for the control model.Where can I get it?
Thanks.
hi Luo:
ShangTao will try to buy the same motor in C2000 guide as LVSERVOMTR module. Will get back to you later. And the motor now using this FY60ASM400-36V, i attached the spec as below. FY60ASM400-36V.pdf
You can order it from TI e-Store as the link below if you need two motor with the coupler.
https://www.ti.com/tool/LVSERVOMTR
If you just need a single motor, you can find the more details as the following link.
https://www.teknic.com/products/hudson…
Other Parts Discussed in Thread: LVSERVOMTR , DRV8301-69M-KIT , DRV8301 HI, dear TI team
Could you give me some advise about the power supply of Drv8301-69M-kit with LVSERVOMTR (60V 7.1A) ?Should the current supply be higher than the peak(or maximum?…
Hi Bui,
Can you tell me specifically what encoder you are using and seeing this Position Counter Error. I don't believe I have seen this while interfacing with the LVSERVOMTR. The position-counter error interrupt flag QFLG[PCE] should only be set if…
Hi Yanming,
thanks. I tested the USER_MOTOR_MAX_CURRENT for the SpinTac motion control and it works as expected where it limited the Iq_ref to the values.
in the torque only mode, i can bypass speed loop and set the Iq_ref_A directly. this works fine. …
Part Number: LAUNCHXL-F280049C Other Parts Discussed in Thread: BOOSTXL-DRV8320RS , LVSERVOMTR I'd like to use the example project servo_drive_with_can_f28004x to see how to properly use an incremental encoder for sensored foc. I'm following the Lab…