Part Number: MCT8315Z Other Parts Discussed in Thread: MCF8316D , MCF8315A , MCF8315C , MCF8315D Tool/software: We use the MCT8315Z as a motor driver chip. During use, we found that the BRAKE function can only decelerate the motor rotation speed to zero…
Part Number: MCT8315Z Tool/software: Does anyone know of a WQFN breakout board that would work with the MCT8315Z? The eval board is great but we need something with basically just the chip (and maybe the decoupling caps)
Thanks!
Part Number: MCT8315Z Tool/software: Dear Support Team,
I have a question regarding the part number mentioned above. The datasheet states that there are three different types of the MCT8315Z: R, H, and T. However, under the orderable device section…
Part Number: MCT8315Z Tool/software: Working with MCT8316Z0RRGFR I see the i-Limit pin should be set to AVDD/2 to disable the cycle-by-cycle current limit. To achive this I tried to implement a voltage divider with two 2kOhm resistors with the midpoint…
Part Number: MCT8315Z Tool/software: I have this problem: sometimes after change DIR from 0 to 1 or from 1 to 0 to change motor direction the motor stop it self for a long time (it seems more or less 1 sec) also if my uC send a PWM different from 0. …
Part Number: MCT8315Z Tool/software: The MCT8315Z data sheet table 8-5 has columns for I_BK "max output from buck" and BUCK_CL "buck current limit" but it doesn't explain the difference between them. The I_BK_CL stated for BUCK_CL is 3x higher than I_BK…
Part Number: MCT8315Z Tool/software: I'm looking into using the MCT8315 motor drive IC in a design and was a bit confused by the configurations available - the datasheet mentions three available configurations:
- MCT8315ZR: SPI configuration interface…
Part Number: MCT8315Z Tool/software: Hi all,
I would like to use one of these motor drivers. I would like to implement current/velocity and position control.
Is it possible? Any suggestion?
Part Number: MCT8315Z Tool/software:
Hi,
This is essentially the same question asked by David Buehlmann a while back about the 8316Z. I'm looking at the MCT8315Z part instead.
I'd like to build a compact stand-alone BLDC control board using the…
Part Number: MCT8315Z Tool/software: In the Hardware variant (ZH) the current from the AVDD , the LDO output) is taken from the VM or from VBK?
Is it fixed or configurable?
