Part Number: MCT8329A Tool/software: Hello,
bacause of PCB layout it would be much easier for me to have current sense resistor at high side.
I don't see it in datasheet but I asume CM voltage on MCT current sense pins not allow to use it as high side…
Hi Kesav,
In the JSON file you have shared two configurations looks not proper, CONST_PWR MAX Speed field are 00.
Can you try the default JSON as is?
{
"signature" : "oneui-register-data" ,
"data" : [
[
{
"idx"…
Hi Simon,
I have not been able to plan this test, I will schedule this test for early next week and get back to you.
Thanks and Best Regards
Venkatadri S
Part Number: MCT8329A Hello team,
Good Day,,
Can i program or set the registers for MCT8329a using any microcontroller via I2C?
for example like Arduino which is having atmaga328p.
Part Number: MCT8329A Tool/software: Hello
Is it possible to get the motor to start up very slowly and gradually build up to the desired speed using a MCT8329A motor controller?
I'm finding that the motor runs at a higher frequency before dropping down…
Part Number: MCT8329A Tool/software: Hello
I am driving a 48 V motor with an MCT8329A gate driver on a custom board. The speed of the motor is controlled by the user using a footpedal.
The MCT8329A is configured to: - use IPD - drive the motor with a PWM…
Part Number: MCT8329A Tool/software: Hello
I am setting the CLR_FLT bit in MCT8329's ALGO_CTRL1 EEPROM and am expecting the CONTROLLER_FAULT_STATUS EEPROM's LOSS_OF_SYNC and MTR_LCK bits to be cleared. This does not happen.
I've also tried adding…
Hi Jonas,
in the MCT8329A, DC_BATT_POW and DC_BUS_CURR are calculated with the assumption that the shunt resistance is 10 mΩ. To convert these values into the correct value, the values need to be scaled to the value of RSHUNT being used. Use the…