Hi, Joshua
1. Speed loop KP, KI were set to arbitrary values.
2. Current loop KP, KI values were automatically found by Motorstudio.
- KP : 0x374
- KI : 0x11f
3. BEMF was calculated based on the measured waveform.
The calculated values were similar to…
Hello Joshua,
Thanks for your support. I changed GUI from MCF8316A_GUI 1.1.9 to motorstudio-0.1.12 and motor spins. But I found the output A, B, C are square wave, could you kindly tell me how to sine wave? Thanks!
BR
Jiawei
Hi Eric,
Tks for the supplement here, it is more clear to understand it.
one more question is that , we use the MCF8316AEVM with MCF8316A_GUI, it works. but cannot work with MOTOR GUI.
or do we need burn new code for MCF8316AEVM and they have below relastionship…
Part Number: MCF8329EVM Other Parts Discussed in Thread: MOTORSTUDIO , , MCF8329A , MCF8316A In the MotorStudio software for the MCF8329EVM, Continuous Space Vector Modulation enable is grayed out. I also don't see it mentioned in the datasheet. Is that…
Part Number: MCF8329EVM Other Parts Discussed in Thread: MCF8329A , MOTORSTUDIO , , MCT8329A I am trying to get a motor to run a bit faster than the top speed I'm currently achieving with the MCF8329A (at a fixed bus voltage). Preferably close to the…
Part Number: MCF8329EVM Other Parts Discussed in Thread: MOTORSTUDIO , MSP430FR2355
Hi support team.
I purchased MCF8329EVM. However, the GUI(Motorstudio) does not recognize EVM. I configured the hardware according to the user's guide, installed the GUI…
Hi!
As described in the FAQ, LED D7 lights up immediately after plugging in USB, so the EVM has the new MSP430 firmware.
We do not have a MSP430 LaunchPad available, and cannot use check or flash firmware onto the MCF8316AEVM.
On launching the MOTORSTUDIO…
Using MotorStudio, I have found by trial and error that if I pre-load the Motor Parameters in the settings page I can make the motor rotate. Yay!
but the MPET does not seem to be able to estimate or measure the MPET Results.
What would help is some kind…
Part Number: MCF8316AEVM Other Parts Discussed in Thread: MOTORSTUDIO Hi there,
I noticed the Errata #8, that the I2C can't read registers when the motor is spinning. And I've verified this point, that once we wrote the DIGITAL_SPEED_CTRL (0xEC…
Part Number: MCF8329EVM Other Parts Discussed in Thread: MOTORSTUDIO , , MCF8316A , MCF8329A I am trying to get a MCF8329AEVM working with a small 100W 10 pole motor running at 36V. Running the board standalone, the motor spins nicely, with speed controlled…