Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Other Parts Discussed in Thread: MSP430F155 hi all
hi all while i searching the 8mhz crystal in digikey for my msp430f155 controller i got many crystal with the different load capacitance .. so kindly suggest me the load capacitance value for my controller…
Part Number: MSP430F2618 Other Parts Discussed in Thread: MSP430F1611 , Hello
I am trying to replace the old MSP430F1611 with a MSP430F2618.
I am using ImageCraft IDE for ICC430 with NoICE430.
From the old code i was using seems everything to work as intended…
Other Parts Discussed in Thread: MSP430F155 is it OK to use an external clock instead of a crystal. I have a 1.0Mhz clock avaiiable and would rather just use it instead of a crystal. I am running out of room and would rather not add another part. I am…
Other Parts Discussed in Thread: MSP430F155 hi all,
am a beginner and am trying to configure my msp430f155 controller to operate at 8 mhz speed..so i purchased a external 8 mhz crystal with a load capacitance of 20pf.. so i connected c1=33pf,c2=33pf…
Other Parts Discussed in Thread: MSP430F155 Hi I am bit new to msp430 controller, In my project i am using msp430f155 controller.....In adc if i use external reference my result will be correct ....but if i am using internal reference generator my answer…
Other Parts Discussed in Thread: MSP430F155 Hi I am bit new to msp430 controller,
In my project i am using msp430f155 controller.....In adc if i use external reference my result will be correct ....but if i am using internal reference generator my answer…
Other Parts Discussed in Thread: MSP430F2618 , MSP430F155 hi am using msp430f2618 controller i made my own pcb now the problem is if am setting my P1.5 as a output port means am getting only 2.68v on that pin since my vcc is3.22v only.and i did t connect…
Other Parts Discussed in Thread: MSP430F155 Hi,
I'm trying to get as fast conversion rate as possible by using msp430f155 12-b ADC. I'm using repeat single-channel mode and I'm quite far from 200 ksps. What I'm doing wrong or is it impossible…
hi all
I have a problem very similar to yours. Our company released around 50 product samples based on MSP430F155 (very old chips :P ), and got 2 broken pieces back. I checked the memory and found that the calibration data stored in Info Flash were corrupted…
