Other Parts Discussed in Thread: MSP430F4152 hello everyone I hope you are well
I started working on a project for a water meter I bought this meter and when I opened it I found this electronic circuit with sensor and a ti microcontroller (MSP430F4152…
Part Number: MSP430F4152 Tool/software: Code Composer Studio Hello,
I want a delay of 0.5 sec (in msp430f4152).
But I do not want to use timer.
My crystal connection is 32768 Hz.
can I use the in build code "_delay_cycle ()" for mspf4152.
If…
Part Number: MSP430F4152 Tool/software: Code Composer Studio hello,
I am using MSP430F4152.
I want to use that in 600 bps.What will be its baud rate (UCA0BR0).
And also UCA0MCTL value.
(I want to use it on 600 bps only)
And also want to check…
Part Number: MSP430F4152 Other Parts Discussed in Thread: MSP-TS430PM64A , , UNIFLASH , MSP430F2619 Hello,
When my customer tries to access JTAG with a firmware update after mass production, the tool denies access. The error when writing MSP-GANG and…
In such case, it should be something that works randomly.
We have been producing more than 200 thousand devices per year for the last 5 or 6 years. These devices integrate the MSP430F4152 MCU in combination with 3 version of firmware.
All FW versions…
Hi. thank you for answer.
Actually, I am testing basicly to see power consumtion of MSP430F4152
I suppouse that DCO is 1 Mhz because I did not configure clock. DCO is default.
My code is below. is this not sufficient to enter LPM3 ? I think there…
Part Number: MSP430F4152 I have downloaded one demo code for i2c communication for MSP430F4152 controller
i have 32.768Khz external crystal and 4.7K pullup resistors are connected to the SDA and SCL line
and i checked signals on pin 1 and 2 but it…
Hello,
The Watchdog timer clock source is ACLK or SMCLK. The ACLK and SMCLK is from external crystal XT1 or XT2.
The accuracy of msp430f4152 watchdog clock depends on the accuracy of external crystal used in your board.
Part Number: MSP430F4152 Other Parts Discussed in Thread: MSP-FET
We are using the MSP430F4152 and programming via SBW. Using the Elprotronic software for programming, we are unable to blow the JTAG security fuse.
A forum post suggested adding a…
