Search tips
Showing 50 results View by: Thread Post Sort by

  • MUX508: max pulse current

    Part Number: MUX508 One of my customers is using ADG508AKRZ we want to replace it with MUX508IDR. They have a question concerning the max pulse current – the ADI component specifies a max pulsed current (S or D) of 40mA for 1ms (see below). Is there…

  • RE: MUX508: EN operation

    Hi Hirotaka, I do not understand why the voltage drop can go to -6.4V. -6.4V does not seem to be charge injection effect only. If you believe charge injection is the root cause, here is the experiment I would do. Currently, their S/H is RC topology…
    • Answered

  • RE: TINA/Spice/MUX508: SPICE Model

    Resolved
    Ok, lets see if I understand, if I select the link to download the Spice Model, it will instead download a TINA model.
    • Answered

  • MUX508: Do you have any analog MUX which can be applied about 10V to input when MUX is powered off?

    Resolved
    Part Number: MUX508 Other Parts Discussed in Thread: MPC508 Hello guys, One of my customers was about to use MUX508 for their new products. But they stopped to use the MUX because they need MUX which can be applied about 15V to input when the MUX…
    • Resolved
    • Answered

  • MUX508: Type selection of switch IC

    Resolved
    Part Number: MUX508 Hello: Recently, I have chosen the two switch IC, the Maxim has MAX4508/9, also just saw TI has MUX508/9, whether can replace, and whether have more advantage? At the same time, I would like to inquire about the key parameters…
    • Resolved

  • MUX508: Leakage currents at lower voltages (<15V)

    TI Thinks Resolved
    Part Number: MUX508 Other Parts Discussed in Thread: MUX36S08 Hello All, My customer is considering application of MUX508 at system with Vin about 5V. The customer very cares about leakage currents. TI comperes with another vendor. Another vendor provides…

  • RE: MUX508: The break-before-make delay is too long to be accepted by customer

    Zhengxing, We haven't seen a response from you in a while . Have you resolved this issue? We are going to close this issue but you may reply to reopen the case. Thank you, Adam

  • ADS8665: Signal settling time across Analog Front End

    TI Thinks Resolved
    Part Number: ADS8665 Other Parts Discussed in Thread: MUX508 , ADS8661W We are using ADS8665 in our design. To read up to 8 analog inputs, MUX508 is used to switch between channels. My question is, what is the signal settling time across 8665 AFE when…

  • MUX507: MUX507 HV input channel impact to adjacent channels

    TI Thinks Resolved
    Part Number: MUX507 Other Parts Discussed in Thread: MUX508 , TMUX7308F Hi Team, my customer design MUX507 for analog input channel multiplexer, however their end customer connect +22V to CH15 and find CH8 signal has 3V DC offset. Please refer to…

  • TMUX4051: Graphs of leakage current vs. tempersature and charge injection vs. source voltage

    TI Thinks Resolved
    Part Number: TMUX4051 Other Parts Discussed in Thread: MUX508 , CD4051B , , TMUX1108 The (preliminary) datasheet so far doesn't give any plots of Ion or Ioff leakage currents vs. temperature and charge injection versus source voltage for comparisons to…

Didn't find what you are looking for? Post a new question.