Part Number: ONET1141L The schematic diagram is as follows.When I change the register data, the output signal does not change at all. The signal is the same as the default setting. I try to write new data into each register, but the output does not change…
Part Number: ONET1141L Hello There,
we use ONET1141L as laser diode driver for 10mW laser diode in closed loop feedback control though monitoring photo diode (MPD) built in the laser diode.
We use the laser driver for 100M transmitter circuit. We are…
Part Number: ONET1141L I want to design a closed loop APC application for my CW laser. No modulation is required. Only constant Laser Power is required in my application.
Can I used ONET1141L in my application.?
Part Number: ONET1141L Dear all,
I'm facing a problem with the ONET1141L mounted on a PCB of my own.
It seems that, no matter what, the chip turns into Fault state, asserting the FLT output after any communication through I2C protocol. I've tried several…
Part Number: ONET1141L Always Thank you for supprts.
I have a question about the APC operation of ONET1141L.
I am currently using the ONET1141L to evaluate pulse driving of Laser Diode.
1. Please explain the APC control operation in APC mode (in closed…
Part Number: ONET1141L Hello, My name is haruyoshi yamashita.
I think that ONET1141L can support electroabsorptive modulated laser (EML).
Can the ONET1141L support normal laser diodes(e.g. rlt940-200gs.pdf)?
Any thought and any answers would be appliciated…
Part Number: ONET1141L Hi team,
We have a question related to ONT1141L:
In reg6, this is the register used for setting EQ at input, but from the datasheet, it seems that there is no the specific value set(dB). Could you help us give the detail value…
Part Number: ONET1141L Hi Everybody
I have questions.
1. If I use data input DIN+ with 0 ~ 2.0V only (don't use DIN-). And then do I have to float DIN-? or connect to GND?
2. If I use data input as question 1, ONET1141 driver laser well?
3. DIN impedence…
