Hi Nasser.
Sorry for the delay in response. I appreciate the guidance on how to take the measurement but we lack the a spectrum analyzer so I think we are out of luck. Marking as resolved even if I'm not the biggest fan of how it was resolved. :-)
…
Part Number: ONET8501P Other Parts Discussed in Thread: ONET1191P I have a singled-ended SMA source going into a ONET8501P as shown below. I then take the output and send one of the differential outputs to a AC-coupled 50-terminnated monitor and the other…
Part Number: ONET8501P Dear TI, my First Question is: is the differential input realy like in the blockchart with 100Ohm terminated or is there a CML logic with both 50Ohm to VCC? my second question: Can I use the ONET with a single ended 50 Ohm matched input…
Part Number: ONET8501P Hello team,
Datasheet describes the response time (T_DIS) when DIS pin is asserted. On the contrary, I want to know the response time when DIS pin is deasserted. How much time does it take to get the device enable state after Dis…
Part Number: ONET8501P Could you please help provide the max/min value or variance of following parameters?
1. Propagation delay( from DIN+/- to DOUT+/-) 2. Propagation delay variation (caused by individual chip differences)
Part Number: ONET8501V Other Parts Discussed in Thread: ONET8501P Hello,
My customer is looking for an alternative solution for the DS1878.
Is there a way or device to replace DS1878 functions when using ONET8501V and/or ONET8501P?
Thank you.
JH
Part Number: ONET8501P Other Parts Discussed in Thread: LMX2492 , I am trying to find an oscillator that can generate a 10GHz signal. I found the LMX2492 from TI on Digikey that can handle these specs ( https://www.digikey.com/product-detail/en/texas-instruments…
Part Number: ONET8501P
Hi team,
My customer wants to know ONET8501P default status of outputs and default output amplitude.
ONET8501P has Dis pin and DIS register bit.
I have following 3 questions.
(1) Which one is given priority? Is it pin or register…
Part Number: ONET4291PA Other Parts Discussed in Thread: ONET8501P , ONET1151L , ONET4211LD , ONET4201LD Dear Support,
Could you confirm if our ONET4291PA and ONET8501P + Laser Driver ONET1151L are recommended for a 1.25Gbps Ethernet transmission (direct…
Other Parts Discussed in Thread: ONET8501P , ONET4291PA , USB2ANY Hallo TI Team,
I want to make test board for ONET8501P and ONET4291PA. For the data rate selection, can I use USB2ANY or DSP Dongle EVM? Or what would TI suggest? Please give me also the…