Part Number: TLV171-Q1 Other Parts Discussed in Thread: OPA171-Q1 , Hi, team
Is there any comparison test for immunity with OPA171-Q1 ?
Customer wishes lower cost solution with TLV171-Q1 but wondering if it has weaker for immunity performance.
…
Part Number: OPA171 Other Parts Discussed in Thread: TINA-TI I am using this device to measure the current of a power supply
The device is configured as an inverting amplifier
Power supply +/-15V
Rfeedback = 100k, Rgain = 1k
also a 1k resistor…
Part Number: OPA171 Other Parts Discussed in Thread: TLV171 , , OPA348 Dear support team
may i have your help to check if OPA171AIDBVR has internal clamp diode from IN+/- to VDD as following red circle
since my customer facing the issues because…
Other Parts Discussed in Thread: OPA171 we using OPA171 for our design，I have question as follow，if the PIN3 Voltage is equal to the PIN4 Voltage，however I want to konw the output is high or low？the Schematic and waveform as follows；but in the Datasheet…
Part Number: OPA171 Other Parts Discussed in Thread: TINA-TI ,
Tool/software: TINA-TI or Spice Models
I have a problem with simulation of an inverting amplifier using the OPA171.
Link to WEBENCH design: https://webench.ti.com/appinfo/webench/scripts…
Part Number: OPA171 Other Parts Discussed in Thread: OPA320 The OPA171 web page and datasheet description state that the device is capable of operating with supplies as low as 2.7V (+/-1.35V). However, the "Recommended Operating Conditions" state that…
Hi JC,
Thanks for your reply!
The model I used was download from the website the same as you pasted.
http://www.ti.com/product/opa171/toolssoftware
but I found that bakc to back diodes were not modeled in the model.
I have to use modified model…
