Part Number: OPA192 Other Parts Discussed in Thread: OPA2192 , INA296A Hi,
I am using an op-amp configuration as shown in the attached image for converting 0.01V pk-pk sine waveform (ac output current of the inverter, around 100A pk-pk, derived from…
Other Parts Discussed in Thread: OPA192 , TLV9002 , OPA2392 Hello,
I want to make this Analog thermostat with relay PCB.
https://www.pcbway.com/project/shareproject/Analogue_Thermostat_with_Relay_6cfef013.html
This project uses an MCP6002. Can I…
Part Number: OPA192 Other Parts Discussed in Thread: OPA627 Hi team,
While going through oure precision video Stability- isolator resistor, the dual feedback is introduced as following:
And the design steps are ad below, could you pls help to expalin…
Part Number: OPA192 Hello team,
DELTA is wondering to know how to test the PSRR/CMRR to obtain likely curve below.
We found the useful website below. but it looks it doesn't mention more detail about the setup and test method with BW.
PSRR:
https…
Part Number: OPA192 Other Parts Discussed in Thread: XTR111 ,
I am designing an iepe signal conditioner and as seen in the introduction I have a 2nd order butterworth high pass filter.. When the sensor (load) is not connected, the current source with…
Part Number: OPA192 Hi all,
I am now trying to simulate the OPA192.
And I build the circuit using Eagle S/W (Our in-campus pcb circuit fabrication tool only accepts Eagle. So it's unchangeable) and I am having trouble in mapping the OPA192 component…
Part Number: OPA192 Other Parts Discussed in Thread: AMC1300 Hi Team,
Can you please help check the design below?
This is a multi-output isolated supply using opa192 opamp for reading ADC but they are facing the issue in high power side, 100v 30A…
Part Number: OPA192 Other Parts Discussed in Thread: OPA549 , OPA567 , OPA569
Good day everyone, I need to design a current amplifier circuit that drives approximately 220 mH coil, 2 Ohm series resistance with an alternating current of 25-50 kHz, 5V…
