Part Number: OPA2626 Other Parts Discussed in Thread: THS4551 , , TINA-TI
Hello TI Team,
I am designing the analog front end for a 14-bit pipeline ADC . My input signal is a pseudo-digital pulse waveform coming from the source, and it is currently…
Part Number: OPA2626 Tool/software: Hello
I perform a simulation to check the output of OPA2626 when the input voltage is out of range. But the result is not what I expected.
Here I use 3.3V to supply OPA2626, so VCM should be less than 3.3-1.15…
Part Number: OPA2626 Other Parts Discussed in Thread: OPA2376 Tool/software: Does TI use a new logo to replace the original logo? It seems the original map is not used.
Part Number: OPA2626 Other Parts Discussed in Thread: OPA365 , OPA837 , OPA863A , OPA620 Could you propose a single fast Op Amp
GBP>50MHz
offset voltage < 500uV
unity gain stable
And I don't want a SHDN pin, the package could be SOT23/SC70/SOIC…
Part Number: OPA2626 Other Parts Discussed in Thread: OPA350 , OPA626 , , TINA-TI , OPA607 , OPA810 , TLV365 , OPA2810 , TLV2365 , OPA2607 , OPA838 , OPA625 , OPA2625 Tool/software: Hello
I have run simulation for the circuit below, when I use OPA350…
Part Number: ADS124S08 Other Parts Discussed in Thread: OPA2626 , Hi team,
We are using the OPA2626 op amp to convert the current from the IDAC in ADS124S08 to a voltage. Can you tell me if the IDAC acts as a source or sink for ADS124S08?
Best regards…
Part Number: OPA2626 Tool/software:
Kindly help with below specifications for part OPA2626IDGKR
–3dB Frequency
Input Capacitance Differential Mode
Input capacitance Common Mode
Input Resistance Differential Mode
Input Resistance Common…
Part Number: OPA2626 Tool/software: Hello
I would like to perform a compensation of the offset voltage caused by OPA2626.
Is there a typical value of the drift? As for offset voltage drift, it is +/-4uV/℃. Does that mean it has 2 directions.
For…
Part Number: OPA2626 Tool/software: To minimize the input bias current impact on the output of OPA2626, I understand it is necessary to match the impedance.
For Invert Input Amplifier, I should add a R=RF//RG in the Non-invert Input to match the impedance…
Part Number: OPA2626 Other Parts Discussed in Thread: OPA626 Hello,
I'm simulating a simple noninverting circuit with the OPA626 in OrCAD PSpice 17.2. It runs fine, if the voltage at the +Input is 0.5 * (VCC-VEE). If it deviates by an offset from this…
